Report Review for product Turret Board - Blank, 189 Holes, 10-1/8" x 2-5/8"

Problem: These turret boards do not provide a snug fit for the turret model # S-HTUR-B or S-HTUR-D that AES provides for these boards. The description above states that they are 3 mm holes. This is not the case. The holes in the boards are approximately 2.6 ~ 2.7 mm wide, whilst the turrets are 2 mm wide. The turrets cannot be held into their respective holes on the turret board by themselves when the board is flipped over to stake the turrets. They need to be held in place by hand and this process only allows the staking of one turret at a time. This is disappointing and a waste of time. Once staked, they do stay in place but the staking process is tedious and lengthy as a result.

Solution: Provide turret boards with smaller holes or turrets with wider shafts, and/or clarify your description for ALL turret products. At the end of the day, the turrets should be a snug fit in the holes to speed up the staking process and allow you to complete your layout in one session, then stake in another session (as is the case with other manufacturers).