Clearance Items
Low-mu triode designed for use as the vertical deflection amplifier in television receivers.
$12.90
by Kevin O'Connor
The evolution of guitar amp circuits becomes a revolution! The Ultimate Tone, Volume 6 takes you through advanced DC Power Scaling methods; reveals the secrets of Dumble amps; explores the truth about high-gain preamps; demonstrates how to build Z-B-X push-pull power amps with a single power tube; simplifies the design of 400W+ tube amps - methods that can be applied to any power level; presents class-G tube amps where 100W of output has the same waste heat as a 25W amp; explores modern mains control and sustain circuitry.
$85.00
Miniature double didoe, high-mu triode intended for use as a second detector audio amplifier. It is designed for operation where the heater and plate voltages are supplied directly from a 12-volt automotive storage battery.
$3.90
- Primary 115 VAC, 60 Hz.
- Secondary 60 C.T.
- All secondaries center tapped, VAC (RMS)
- Enclosed, 4 hole chassis mount.
- Minimum 6" long leads.
- Dual bobbin design - no electrostatic shield required.
- Class B insulation (130 degrees C).
- Hi-Pot test of 2,000V RMS.
- UL listed (# E50394) & CSA certified (209651).
$76.40
Eddystone 26827PSLA enclosure with similar dimensions to the Hammond 1590D enclosure. The Eddystone version has sharper corners for a distinctive appearance. This enclosure is a great option for 1590D style builds.
- Rugged, diecast aluminum alloy (tough - yet easy to machine), electronic instrument enclosure.
- Aluminum alloy to BS1490, LM2M - supplied in natural finish.
- Eddystone designed. The Eddystone brand was purchased by Hammond in 1998.
- Lap joint construction provides protection against access of dust and splashing water. Also provides excellent EMC performance.
- Lids are retained by M3.5 x 12 countersunk screws (POZIDRIV No. 2 head).
- Countersunk lid holes.
- Designed to meet IP54.
- Low side wall draft angle (2 degrees or less) for easy P.C. board mounting.
$28.95
High performance, ultrafast diodes. Improve efficiency, reduce noise, allow higher frequency operation.
$3.60
Save 10%
Originally: $4.00
Half-wave high-vacuum rectifier which may be used with either choke or condenser input to the filter.
$27.35
300V wire nuts for use with 18 gauge through 22 gauge wires. These wire nuts are great for use on appliances, televisions, stereos, antennas, or for any small wiring application. Rated for up to 105°C.
$1.23
Save 15%
Originally: $1.45
package of 20
High vacuum full wave rectifying tube.
$6.45
Save 50%
Originally: $12.90
Vintage style stamped tuning machine set with solid metal oval buttons mounted on a plate. These nickel finished tuners look great on vintage and Fender® style guitars. The gear ratio is 15:1. All mounting hardware is included in this six on a plate tuner set.
$25.46
Save 15%
Originally: $29.95
Colors Available:
$10.90
The premium subminiature type 5902 is a beam power pentode designed for use as an audio amplifier. It is intended for operation under conditions of severe shock, vibration, high temperature, and high altitude.
$9.90
The N12D is able to return the feel, the warmth and the character of a classic guitar amplifier, but also the treble content and the complex harmonics of the overdrive, modulation, delay and reverb effects, as well as the crisp, natural tone of an amplified acoustic guitar. The Neodymium magnet design allows a weight reduction to only 2.4kgs.
$124.77
Save 40%
Originally: $207.95
Triple grid sharp cut-off amplifier. It is designed for service in high gain RF and IF amplifier applications and for limited service in FM receivers. The double cathode connection is useful in reducing cathode circuit coupling.
Starting at $4.50
A worthy successor to the Vintage 10, the G10 Vintage is a 10" speaker with bags of attitude. Using powerful ceramic magnets and the same voice coil design as the Vintage 30, the G10 packs an impressive punch with its 60W power handling. With the fast response of a 10" but with the strong and creamy vocal tones of a 12", the G10 is the ideal choice to add depth to hollow-sounding amps, or for players who want to get humbucker-type girth from single-coils. Can be used singly to add vocal warmth to small valve combos, or in quartets for a weightier but still lively attack.
$109.00
Miniature remote-cutoff pentode intended for use as a radio-frequency or intermediate frequency amplifier in automobile radio receivers.
$3.90
Amphenol "T-Series (Pro Range)" Phone Plug. 1/4" Mono straight plug with large Jaws cable clamp, metal backshell and black finish. Internal cable clamp fits cable outer diameters ranging from 0.236” to 0.295” (6 mm to 7.5 mm).
$7.01
Save 15%
Originally: $8.25
Black Cliff K5 knob with short indicator line. ¼" shaft with set screw. Replacement for Marshall. Measures 0.75" in height. See P-K342-NOI for a version with no indicator line.
$2.95
- Over designed for single ended tube output circuits (triode, tetrode or pentode tubes).
- Enclosed (shielded), 4 slot, above chassis Type 'X' mounting.
- Frequency response at least 20 Hz. to 20 Khz. at full rated power (± 1 db max. ref.
$223.75
Original Celestion Guitar Speaker Recone Kit. For 12" Celestion G12 Alnico Blue (our SKU's P-A-G12-8 and P-A-G12-15)
$115.00
A modern version of the Tune-o-matic style bridge for guitars. Pre-notched titanium saddles with an individual saddle intonation screw retained by mini hex nuts for each saddle. Threaded thumbwheel style studs and anchor bushings. Hardware included.
$70.55
The Smooth BS 15N/350A is a 15" neodymium speaker with 350 watts of power. Smooth Sound speakers are extremely clean and round with superb headroom. Equipped with neodymium magnets and aluminium baskets, they offer great linear excursion and dynamics. They are ideal for modern styles where extended low end is required. Neodymium magnets offer a 50% reduction in weight guaranteeing very light systems. The proprietary aluminium basket was specially designed to avoid sound wave reflections on the rear side of the cone, thereby allowing for faster and better cooling of both the voice coil and the air moved by it. The 15'' bass speaker provides a full and warm low-end that will fill the room.
The OOD9 is the updated version of the original Maxon overdrive pedal, the OD880. This overdrive is equipped with NJM4558D op amps for a warm and low-noise overdrive that pairs perfectly with tube amplifiers and other distortion pedals. The OOD9 offers a dynamic response that preserves the tone of the input providing a smooth and clear overdriven sound.
$157.95
Colors Available:
$15.75