Shape your sound with the Tone Attack. 12 o'clock settings give an approximate unity gain with the pedal. Rotate the treble or bass knob counterclockwise to cut the corresponding frequencies. Rotate these same knobs clockwise to boost the frequency bands. The master boost knob can be used to attenuate your signal or push your tone to screaming loud volumes. MOD® Kits are designed to give both novice and experienced musicians the opportunity to build their own amps and effects pedals. All kits come with easy to follow instructions and use point to point wiring. Pre-drilled enclosure and all parts are included. All you need to provide are hand tools, a soldering iron and solder. The Tone Attack operates on a 9V battery or AC adapter, which is not included. The Godlyke 9-volt adapter (M-PAS-S) may be purchased separately to power your new pedal.
All Tube Design (solid-state diodes used only for full-wave rectification)
60W output power into 4, 8, 16 and 20 Ω
1 channel with customizable: tone stack, power tubes, negative feedback, input miller capacitance volt divider/LP filter, and preamp cathode bypass cap (all parts included)
Vintage channel controls: bass, treble and volume
Vintage pilot lamp and screw-on jewel cover for power-on indication
DPDT power switch circuit for instant high-voltage drain in power-off
Carling, SPST footswitch, Off-(On), momentary, normally open with screw terminals. Note: Off-(On) switches may sometimes be referred to as Off-None-(On).
Triple grid sharp cut-off amplifier. It is designed for service in high gain RF and IF amplifier applications and for limited service in FM receivers. The double cathode connection is useful in reducing cathode circuit coupling.
Miniature dual-control heptode designed primarily for use as a combined sync separator and sync clipper in television receivers. Each of the two independent control grids exhibits a sharp cutoff characteristic.
This bridge, popularly referred to as the harmonica bridge is a direct replication of the original using all the same quality fabrication, dimensions and best of all, milled from steel billet to give you the tone you crave. Now there is finally a proper replacement for all those vintage Gibson guitars without having to modify the original instrument! Just when you thought you weren’t going to be able to restore your original hardware, Kluson comes through!
480.820.5411