You are here

Effect Pedals & Parts

Filter these results
Sort By:
products per page
View Mode: List View · Grid View

Pages

(13 pages)
P-ECB-590Screws - Dunlop, MXR, housing screws, package of 4
Genuine Dunlop replacement housing screws for MXR/ Dunlop pedals. Replace lost screws and keep your battery access plate on tight. 6-32 thread, Phillips head.
$1.50
Click to read more
K-970Effects Pedal Kit - MOD® Kits, The Tea Philter, T Filter

The Tea Philter - A T-Filter Pedal Kit The Tea Philter pedal produces a fixed wah tone allowing you to lock it in without rocking the pedal back and forth. Every guitar/wah combination has a certain sweet spot that is perfect for lead and chord work. The Tea Philter lets you dial in everything from your favorite vocal mid-range tone to thick lows. Using point-to-point wiring and easy-to-follow instructions you can have a working fixed wah pedal in a matter of hours. The effect pedal operates on a 9V battery. For a longer lasting option, a 9-volt adapter can be purchased separately.


$31.95
Click to read more
P-RBTDR-3HReverb Module - Accutronics Belton, Digi-Log, Adjustable Decay
A great digital reverb sound that easily replaces a spring reverberation unit

Features:
  • Reverb depth (decay adjustable via 2 external resistors or 1 dual potentiometer
  • Stereo outputs may be summed for mono operation
  • Simple interface: input, output, +5V, and ground
  • AC-coupled input and outputs require no external capacitors

Specifications:


PARAMETER
SYMBOL
MINIMUM
TYPICAL
MAXIMUM
UNIT


Supply Voltage
Vcc
4.5
5.0
5.5
V


Supply Current
Icc

60
100
mA


Input Voltage
Vin


1.5
Vpeak


Voltage Gain


-3

dB (>10kOhm load)


Residual Noise


-77

dBV


Input Impedance
Zin

10k

Ohm


Output Impedance
Zout

220

Ohm


Operating Temperature

-40
$15.95
Click to read more
P-ECB-31Felt Pad - Dunlop, for Wahs
$1.25
Click to read more
P-ECB-67Knob - Dunlop, MXR, small knurled, aluminum
Genuine Dunlop replacement small knurled knob for MXR pedals. Push -on style knob designed for use with knurled shafts.
$2.25
Click to read more
P-ECB-78Potentiometer - Dunlop, 10K linear
Genuine Dunlop replacement potentiometer for wah/volume.
  • 10K Linear
  • Gear included
$13.95
Click to read more
K-950Effects Pedal Kit - MOD® Kits, The Thunderdrive, Overdrive
The Thunderdrive is an overdrive pedal kit that will provide a signal boost at low gain settings and its own distortion at maximum gain settings. You can use it to push your preamp into overdrive or as a source of smooth distortion. Adjusting volume control and gain control results in a wide variety of tones in spite of its simple construction.
This pedal is capable of overdriving the preamp section of your guitar amp or adding its own layer of distortion at lower volume. Using point to point wiring and easy to follow instructions you can have a working overdrive pedal in a matter of hours.
All you need to provide is solder and a soldering iron. Uses 9 volt battery which is not included.
$29.95
Click to read more
P-H553Switch - Carling, Footswitch, SPST, Momentary, On-Off

Carling footswitch, SPST, momentary ON-(OFF) normally closed with solder lugs.


$7.95
$6.95
You save: 13%
Click to read more
M-PAS-CABLE-6Cable - For Power All Systems, C-GY
Included in the PA-9 Power-All System and also sold separately, the Cable-Grey allows the user to power vintage and boutique effect units that run off 9-volt batteries but do not have an external AC power jack.
The Cable-Grey hooks directly to the unit's Battery Snap and can be connected to any of the Power-All daisy chains, or directly to the Power-All.
Cable-Grey is 158.75 mm (approximately 5.25 inches) in length from plug to plug.
NOTE: The Power-All Cable-Grey was designed to hook directly to the battery snap inside a pedal and then provide power to the pedal using an external DC power adaptor.
The wiring of the Cable-Grey’s battery snap is the OPPOSITE of what would normally be needed to connect to a 9-Volt battery.
$3.00
Click to read more
K-955Effects Pedal Kit - MOD® Kits, Thunderdrive Deluxe, Overdrive
The Thunderdrive Deluxe is an overdrive pedal kit that will provide a strong clean signal boost in the early gain settings and smooth distortion at maximum gain settings. Adjusting volume control and gain controls provides a wide variety of tones in spite of it's simple contruction.
The Turbo switch provides an additional boost in volume and less internally generated distortion. The pre-painted black enclosure, red control knobs and red LED indicator give the Thunderdrive Deluxe an understated attractive finish. It is capable of overdriving the preamp section of your guitar amp or adding it's own layer of distortion at lower volume.
This is an easy build kit with point to point wiring and clear, easy to follow instructions. The current draw of this pedal is very low at 1.3 milliamps, allowing for long battery life. All you need to provide is solder, soldering iron and a few simple tools.
$39.95
Click to read more

Pages

(13 pages)
Don't see a product you're looking for? Send us your product suggestions!
Subscribe to RSS - Effect Pedals & Parts