You are here

Effect Pedals & Parts

Filter these results
Sort By:
products per page
View Mode: List View · Grid View

Pages

(12 pages)
P-ECB-78Potentiometer - Dunlop, 10K linear
Genuine Dunlop replacement potentiometer for wah/volume.
  • 10K Linear
  • Gear included
$12.00
$10.80
You save: 10%
Click to read more about this product.
M-PAS-BKit - Power All System Basic, For Effects Pedals

The Power-All PA-9 Digital Power Supply is the world’s first 2000 mA, single outlet power supply designed specifically for guitar effect users. Don’t waste money on batteries or take up valuable space with multiple “wall wart” adaptors or power bricks – the Power-All system can power your entire pedalboard from a single power supply that takes up only one outlet! The Power-All provides 9 volts DC at 2000 milliamps – more than enough current to power dozens of effect pedals, including up to four Line 6 Modelers! The Power-All’s special circuit design offers the lowest noise floor of any digital power supply on the market. The PA-9 now comes with a ferrite-core filter built onto its output cable to further reduce noise and hum.


$24.00
$21.60
You save: 10%
Click to read more about this product.
K-950Effects Pedal Kit - MOD® Kits, The Thunderdrive, Overdrive
The Thunderdrive is an overdrive pedal kit that will provide a signal boost at low gain settings and its own distortion at maximum gain settings. You can use it to push your preamp into overdrive or as a source of smooth distortion. Adjusting volume control and gain control results in a wide variety of tones in spite of its simple construction.
This pedal is capable of overdriving the preamp section of your guitar amp or adding its own layer of distortion at lower volume. Using point to point wiring and easy to follow instructions you can have a working overdrive pedal in a matter of hours.
All you need to provide is solder and a soldering iron. Uses 9 volt battery which is not included.
$29.95
$26.96
You save: 10%
Click to read more about this product.
M-PAS-CABLE-6Cable - For Power All Systems, C-GY
Included in the PA-9 Power-All System and also sold separately, the Cable-Grey allows the user to power vintage and boutique effect units that run off 9-volt batteries but do not have an external AC power jack.
The Cable-Grey hooks directly to the unit's Battery Snap and can be connected to any of the Power-All daisy chains, or directly to the Power-All.
Cable-Grey is 158.75 mm (approximately 5.25 inches) in length from plug to plug.
NOTE: The Power-All Cable-Grey was designed to hook directly to the battery snap inside a pedal and then provide power to the pedal using an external DC power adaptor.
The wiring of the Cable-Grey’s battery snap is the OPPOSITE of what would normally be needed to connect to a 9-Volt battery.
$2.95
$2.66
You save: 10%
Click to read more about this product.
K-955Effects Pedal Kit - MOD® Kits, Thunderdrive Deluxe, Overdrive
The Thunderdrive Deluxe is an overdrive pedal kit that will provide a strong clean signal boost in the early gain settings and smooth distortion at maximum gain settings. Adjusting volume control and gain controls provides a wide variety of tones in spite of it's simple contruction.
The Turbo switch provides an additional boost in volume and less internally generated distortion. The pre-painted black enclosure, red control knobs and red LED indicator give the Thunderdrive Deluxe an understated attractive finish. It is capable of overdriving the preamp section of your guitar amp or adding it's own layer of distortion at lower volume.
This is an easy build kit with point to point wiring and clear, easy to follow instructions. The current draw of this pedal is very low at 1.3 milliamps, allowing for long battery life. All you need to provide is solder, soldering iron and a few simple tools.
$39.95
$35.96
You save: 10%
Click to read more about this product.
K-960Effects Pedal Kit - MOD® Kits, The Trill, Tremolo
The Trill tremolo pedal offers classic tremolo tones in an easy to build kit. The Trill's speed knob provides a wide range from a very slow to rapid fire effect. The depth knob varies the ratio between effected and dry signal.
Using modern, low noise transistors makes operation of The Trill quiet with no signal drop when engaged. The Trill uses true bypass foot switching so it is out of the signal path when not engaged.
All you need to provide is solder and tools! Uses 9 volt battery which is not included.
$43.95
$39.56
You save: 10%
Click to read more about this product.
P-L500Bezel with LED Lamp - 5mm, Red with holder
5 mm diameter Red LED with holder. Perfect for amps and effects. Mounts in a 5/16" diameter chassis hole.
$0.95
$0.86
You save: 9%
Click to read more about this product.
K-975Effects Pedal Kit - MOD® Kits, Ring Resonator, Octave-Up Fuzz
The Ring Resonator is the newest member of the MOD® Kits DIY family. Order now to be one of the first people to get this new octave up fuzz pedal!
The Ring Resonator kit is an octave up fuzz effect; an all analog design that captures those late '60s octave-up fuzz tones. Transformer coupled germanium diodes produce sounds that range from a subtle octave up to thick, harmonically rich sonic textures and synth-like tones. Experimenting with different pickups and tone control settings on your guitar with the Ring Resonator can also produce sitar-like sounds.
MOD® Kits are designed to give novice and experienced musicians the opportunity to build their own amps and effects pedals. All kits come with easy-to-follow instructions and use point-to-point wiring. A pre-drilled enclosure and all necessary parts are included. All you need to provide are hand tools, a soldering iron and solder.
The effect pedal operates on a 9V battery.
$64.95
$58.46
You save: 10%
Click to read more about this product.
S-HLW-CARLINGLocking Washer - Carling (Package of 5)
Flat washer/locking ring. Fits switches that mount to 1/2" chassis holes. A 0.110" length guide tab ensures a locking fit (locking hole is 0.376" from chassis hole center).
$1.50
$1.35
You save: 10%
Click to read more about this product.
P-L200LED Holder - 3mm
Holder for LED.
$0.65
$0.59
You save: 9%
Click to read more about this product.

Pages

(12 pages)
Don't see a product you're looking for? Send us your product suggestions!
Subscribe to RSS - Effect Pedals & Parts