You are here

Effect Pedals & Parts

Adding effects to your signal path is a great way to alter the sound of your guitar. Add reverb, delay, distortion, frequency ranges and other dynamic effects.

Build a kit or purchase parts to make your own!

Filter these results
Sort By:
products per page
View Mode: List View · Grid View

Pages

(13 pages)
M-PAS-CABLE-7Cable - red right-angle reverse-polarity jumper

Included in the Power-All System and also available separately, the Cable-Red/R allows the user to power effect units that have reverse polarity barrel connectors (tip positive/barrel negative). The Cable-Red/R features a tip positive, male barrel connector that is spring-loaded to prevent disconnection. The Cable-Red/R can be hooked to any plug on any of the Power-All daisy chains, or directly to the Power-All.


$3.00
Click to read more
P-ECB-004Power Supply - Dunlop, 18V A/C Adapter

The Dunlop 18V power supply for Dunlop effects will save you some money on batteries and get the right power to your pedal! Features Include:



  • 18 volts of regulated DC current
  • 2.1 mm x 5.5 mm plug with negative center


Compatible Dunlop pedals include:



  • Older Crybaby Multi-Wah
  • SW-95 Slash Wah
  • M108 10-band EQ
  • KFK1 10-band EQ
  • M117R Flanger
  • EVH 117 Flanger
  • DD11 Dime Distortion
  • M134 Chorus
  • M181 Bass Blowtorch


Plus many other pedals requiring an 18vdc power supply!


$15.95
Click to read more
P-RBTSE-99FXDSP Module - Accutronics, 99 Effects (Reverb, Chorus, Delay, +)

The BTSE-99FX Effect board provides 99 different digital audio effects to be used in many audio applications that require sound enhancement. Equipped with a superb quality digital effects processing engine which adds that extra punch needed to make sounds truly stand out. Applications:



  • Guitar/ Keyboard/Bass amplifiers and combos
  • Audio mixing consoles / Powered mixing consoles
  • Stand -alone stereo effect units for studio and PA usage
  • Effects pedals

$32.00
Click to read more
K-P155Battery Clip - 9 Volt with Vinyl Tab

Single standard snap-on 9V battery clip. Features six inch pre-stripped and pre-tinned leads for an easy connection.


$0.60
Click to read more
P-ECB-233Switch - Dunlop, PCM

ECB233 boost / distortion kick switch. Original Dunlop replacement part. Used in the SW95 Crybaby Slash Wah. Through hole PCB mount.


$4.50
Click to read more
P-H590-XSwitch - Footswitch, 3PDT, LED Ring
Colors Available:

3PDT. LED ring requires a 3/4" mounting hole. Foot switch button set screw requires 1.5mm hex key.


Starting at $7.95
Click to read more
P-GRIP-1Pedal Tape - Godlyke, Power Grip, 1 Meter Roll

For the best Pedalboard Dual Lock and Velcro Alternative, try Power-All Power-Grip. Simple, yet ingenious, Power-Grip pedal board tape mates to itself via rows of tiny mushroom-shaped posts that form a much stronger bond than traditional "hook & loop" Velcro fasteners. Just cut to size, apply, and GRIP! Approximately enough for 6 standard-sized pedals


$14.95
Click to read more
K-991Effects Pedal Kit - MOD® Kits, The Rock Bottom, Bass Fuzz

The Rock Bottom is a bass fuzz kit that gives you all of the sizzle you'd expect from a vintage fuzz without sacrificing those low frequencies. Use the blend pot to set your fuzz levels and dial in the volume to get that sound you need. This versatile pedal can be used for the sludgiest bass tones to the cleanest boost and everything in-between.


$43.95
Click to read more
K-996Effects Pedal Kit - MOD® Kits, The Penetrator, Treble Boost

The Penetrator is a treble boost pedal kit with enough gain to cut straight through any mix. This pedal adds glistening harmonics that get loud enough to saturate your amp’s front end. Adjust the level knob to vary the output so there’s no mistaking when you kick this pedal in. Great for solos or when you need your guitar front and center.


$38.95
Click to read more
K-997Effects Pedal Kit - MOD® Kits, Erratic Clutch Deluxe, Fuzz/Divider

The Erratic Clutch Deluxe is a unique effect pedal kit that gives you fuzzy square wave distortion as well as a monophonic sub-octave square wave using a total of only four transistors. The two signals can be used individually or mixed together for a raw and sonically rich synthy output. Full of character and quirk, this pedal will give you a truly original sound. The middle knob is the bias control. This adjusts the pulse width in the initial fuzz stage of the pedal. Set this knob to fit your pickups and playing style. The closer to the center the longer the note will sustain but with that comes more chaotic tracking for the divider. Moving it more clockwise or counterclockwise will give you more predictable note tracking on the divider with less sustain.


$69.95
Click to read more

Pages

(13 pages)
Don't see a product you're looking for? Send us your product suggestions!
Subscribe to RSS - Effect Pedals & Parts