You are here

Effect Pedals & Parts

Adding effects to your signal path is a great way to alter the sound of your guitar. Add reverb, delay, distortion, frequency ranges and other dynamic effects.

Build a kit or purchase parts to make your own!

Filter these results
Sort By:
products per page
View Mode: List View · Grid View

Pages

(13 pages)
P-ECB-9V2Battery Box - Gotoh, Dual, 9 Volt

Dual 9 volt battery box. Two 9V battery compartments, each compartment having its own red and black wires for battery positive and negative connections (4 wires total) allowing for series, parallel or separate connections of two 9V batteries. Four wood screws included. Directions: 1. Refer to the Drawing B and make a hole on guitar body. 57.5 mm (2.26") x 49.5 mm (1.95"), R6 (6 mm = 0.24") 2. Put the box in guitar body and fix it by screws.


$19.00
Click to read more
P-H1590BBCE-PDChassis Box - Diecast Aluminum, 4.67" x 3.68" x 1.18", pre-drilled

Same as Hammond P-H1590BB, but generic manufacture made in Taiwan. Measures 4.67" x 3.68" x 1.18" deep. Holes are drilled for pots, footswitch and jacks. Holes are 1 @ ½" dia., 2 @ 3/8" dia, and 2 @ 8 mm dia.


$9.95
Click to read more
P-H1590N1Chassis Box - Hammond, Diecast Aluminum, 4.77" x 2.6" x 1.39"

Depending on the manufacturer, this enclosure is usually very similar to a 125B.



Aluminum enclosure with countersunk lid that machine screws into drilled and tapped holes. Lap joint construction provides protection from dust and water. Vibra finished, no sharp edges.


$10.81
Click to read more
M-PAS-CABLE-4Cable - Power All, Blue Right Angle Phone Plug Extension Jumper

Included in the Power-All System and also sold separately, the Cable-Blue/R features a right-angle jack that allows users to power effect units that use a 1/8" (3.5 MM) phone plug connector with tip-positive polarity. The Cable-Blue/R can be connected to any male jack on the Cable-5 Daisy Chain, or directly to the PA-9 itself.


$3.00
Click to read more
P-H503Footswitch - DPDT, Momentary, Solder Lugs

DPDT momentary footswitch. AC125V/4A AC250V/2A


$3.95
Click to read more
K-997Effects Pedal Kit - MOD® Kits, The Erratic Clutch Deluxe, Fuzz / Divider

The Erratic Clutch Deluxe is a unique effect pedal kit that gives you fuzzy square wave distortion as well as a monophonic sub-octave square wave using a total of only four transistors. The two signals can be used individually or mixed together for a raw and sonically rich synthy output. Full of character and quirk, this pedal will give you a truly original sound. The middle knob is the bias control. This adjusts the pulse width in the initial fuzz stage of the pedal. Set this knob to fit your pickups and playing style. The closer to the center the longer the note will sustain but with that comes more chaotic tracking for the divider. Moving it more clockwise or counterclockwise will give you more predictable note tracking on the divider with less sustain.


$72.95
Click to read more
P-H-LEHLE-BTN-XFootswitch - Lehle, SPST, Momentary, Soft Click, Long Life

The LEHLE SWITCH BTN is a momentary foot switch. It is housed in an M12 threaded enclosure made of stainless steel. Thanks to the gold plated contact material its life span is at least one million switching cycles electrically and mechanically. Hardware included.


Starting at $13.95
Click to read more
P-RBTDR-1H-XReverb Module - Accutronics Belton, Digi-Log, horizontal mount

A great digital reverb sound that easily replaces a spring reverberation unit. Simple interface requires only input, output, +5V, and ground. Output requires no external capacitors.


Starting at $12.95
Click to read more
P-ECB-GEARGear - for Wah Potentiometer

Generic gear (a.k.a. pinion) for wah-style potentiometers. Outer diameter = 0.48", height = 0.61". Push-on for splined 1/4" shaft. Push-on mounting allows any 1/4" splined shaft potentiometer to be equipped for use with rack and pinion shaft rotation as in a wah pedal.


$1.50
Click to read more
R-VPC01Photocell - Morley, for Effects Pedals

Photocell for Morley effects pedals. Great replacement for LDR1, LDR2 and LDR3 (M79-211564-000) in Morley Pro Series Volume PVO. Sold individually.



A photocell may also be referred to as a photoresistor, LDR, or light dependant resistor.


$2.50
Click to read more

Pages

(13 pages)
Don't see a product you're looking for? Send us your product suggestions!
Subscribe to RSS - Effect Pedals & Parts