You are here

Effect Pedals & Parts

Adding effects to your signal path is a great way to alter the sound of your guitar. Add reverb, delay, distortion, frequency ranges and other dynamic effects.

Build a kit or purchase parts to make your own!

Filter these results
Sort By:
products per page
View Mode: List View · Grid View

Pages

(12 pages)
P-ECB-004Power Supply - Dunlop, 18V A/C Adapter

The Dunlop 18V power supply for Dunlop effects will save you some money on batteries and get the right power to your pedal! Features Include:



  • 18 volts of regulated DC current
  • 2.1 mm x 5.5 mm plug with negative center


Compatible Dunlop pedals include:



  • Older Crybaby Multi-Wah
  • SW-95 Slash Wah
  • M108 10-band EQ
  • KFK1 10-band EQ
  • M117R Flanger
  • EVH 117 Flanger
  • DD11 Dime Distortion
  • M134 Chorus
  • M181 Bass Blowtorch


Plus many other pedals requiring an 18vdc power supply!


$15.95
Click to read more
P-ECB-9V2Battery Box - Gotoh, Dual, 9 Volt

Dual 9 volt battery box. Two 9V battery compartments, each compartment having its own red and black wires for battery positive and negative connections (4 wires total) allowing for series, parallel or separate connections of two 9V batteries. Four wood screws included. Directions: 1. Refer to the Drawing B and make a hole on guitar body. 57.5 mm (2.26") x 49.5 mm (1.95"), R6 (6 mm = 0.24") 2. Put the box in guitar body and fix it by screws.


$19.00
Click to read more
P-H1590DChassis Box - Hammond, Unpainted Aluminum, 7.38" x 4.70" x 2.05"
  • Rugged, diecast aluminum alloy (tough yet easy to machine), electronic instrument enclosure.
  • Lap joint construction provides protection against access of dust and splashing water. Also provides for improved EMI/RFI shielding.
  • Vibra finished for a smooth surface with no sharp edges.
  • Six 6-32 x ½" machine screws secure lid - into tapped holes.
  • Designed to meet IP54.
  • Low side wall draft angle (2 degrees or less) for easy P.C.

$19.34
Click to read more
M-PAS-SPower Supply - Power All System, 9V, 2000mA, for Effects Pedals

The PA-9 Power-All is the world's first 2000 mA, single outlet power supply designed specifically for guitar effect users. Don't waste money on batteries or take up valuable space with multiple "wall wart" adaptors or power bricks - the Power-All system can power your entire pedalboard from a single power supply that takes up only one outlet! The Power-All's special circuit design offers the lowest noise floor of any digital power supply on the market. The PA-9S now comes with a ferrite-core filter built onto its output cable to further reduce noise and hum.


$19.95
Click to read more
P-ECB-24BPotentiometer - Dunlop, Hot Potz II Crybaby, 100 kΩ

Hot Potz II Crybaby Pot. for newer Crybaby models. Made by Beckman. 100 kΩ. Original Dunlop replacement part. The same tone and sweep characteristics as the original Cry Baby Hot Potz potentiometer with low wiper noise and extended life.


$20.59
Click to read more
P-H1590EChassis Box - Hammond, Unpainted Aluminum, 7.38" x 4.70" x 3.07"
  • Rugged, diecast aluminum alloy (tough yet easy to machine), electronic instrument enclosure.
  • Lap joint construction provides protection against access of dust and splashing water. Also provides for improved EMI/RFI shielding.
  • Vibra finished for a smooth surface with no sharp edges.
  • Six 6-32 x ½" machine screws secure lid - into tapped holes.
  • Designed to meet IP54.
  • Low side wall draft angle (2 degrees or less) for easy P.C. board mounting.
  • Dimensions shown are exterior dimensions.
$21.69
Click to read more
P-ECB-24APotentiometer - Dunlop Hot Potz, 470 kΩ

Used in Jimi Hendrix's WAH and Dunlop volume pedal. 470 kΩ. Original Dunlop replacement part.


$22.95
Click to read more
P-ECB-24CPotentiometer - Dunlop, 20 kΩ, Custom Taper, Wah Pot, for Bass

Custom taper 20k Dunlop potentiometer used in 105Q Crybaby Bass Wah. 1 million cycles, maintenance free.


$22.95
Click to read more
P-ECB-25PC Board - Dunlop, for Crybaby

Original Crybaby replacement circuit board for pedals made after 1990. Original Dunlop replacement part.


$22.95
Click to read more
P-H1590VChassis Box - Hammond, Unpainted Aluminum, 4.70" x 4.70" x 3.54"

Special Order Item

  • Rugged, diecast aluminum alloy (tough yet easy to machine), electronic instrument enclosure.
  • Lap joint construction provides protection against access of dust and splashing water. Also provides for improved EMI/RFI shielding.
  • Vibra finished for a smooth surface with no sharp edges.
  • Four 6-32 x ½" machine screws secure lid - into tapped holes.
  • Designed to meet IP54.
  • Low side wall draft angle (2 degrees or less) for easy P.C.
$23.15
Note: special order items require additional lead time. See our page on special order items.
Note: this is a special order item.
Click to read more

Pages

(12 pages)
Don't see a product you're looking for? Send us your product suggestions!
Subscribe to RSS - Effect Pedals & Parts