You are here

Effect Pedals & Parts

Adding effects to your signal path is a great way to alter the sound of your guitar. Add reverb, delay, distortion, frequency ranges and other dynamic effects.

Build a kit or purchase parts to make your own!

Filter these results
Sort By:
products per page
View Mode: List View · Grid View

Pages

(14 pages)
P-ECB-003Power Supply - Dunlop, 9V, 200mA, Barrel, Center Negative

Dunlop ECB003 US wallwart power supply. Barrel connector.



  • Voltage: 9VDC
  • Current: 200mA
  • Tip Negative; Sleeve positive

$12.50
Click to read more
P-GRIP-1Pedal Tape - Godlyke, Power Grip, 1 Meter Roll

For the best Pedalboard Dual Lock and Velcro Alternative, try Power-All Power-Grip. Simple, yet ingenious, Power-Grip pedal board tape mates to itself via rows of tiny mushroom-shaped posts that form a much stronger bond than traditional "hook & loop" Velcro fasteners. Just cut to size, apply, and GRIP! Approximately enough for 6 standard-sized pedals


$14.95
Click to read more
M-RAT2Effects Pedal - ProCo, Rat-2, Distortion

The RAT2 is the classic distortion pedal in the Pro Co RAT family. It has a unique tone structure that other effect devices are measured against. The beauty of the RAT 2 lies in its versatility. Used as a primary distortion, it excels at arena rock rhythm tones and soaring leads.


$82.95
Click to read more
P-ECB-004Power Supply - Dunlop, 18V A/C Adapter

The Dunlop 18V power supply for Dunlop effects will save you some money on batteries and get the right power to your pedal! Features Include:



  • 18 volts of regulated DC current
  • 2.1 mm x 5.5 mm plug with negative center


Compatible Dunlop pedals include:



  • Older Crybaby Multi-Wah
  • SW-95 Slash Wah
  • M108 10-band EQ
  • KFK1 10-band EQ
  • M117R Flanger
  • EVH 117 Flanger
  • DD11 Dime Distortion
  • M134 Chorus
  • M181 Bass Blowtorch


Plus many other pedals requiring an 18vdc power supply!


$15.95
Click to read more
R-V1MJ-SSPotentiometer - Fender®, 1MΩ, J Taper, Solid Shaft, Panel Mount

Pot, Solid Shaft, 1M J Taper


$7.50
Click to read more
P-H1590EChassis Box - Hammond, Diecast Aluminum, 7.38" x 4.70" x 3.07"
  • Rugged, diecast aluminum alloy (tough yet easy to machine), electronic instrument enclosure.
  • Lap joint construction provides protection against access of dust and splashing water. Also provides for improved EMI/RFI shielding.
  • Vibra finished for a smooth surface with no sharp edges.
  • Six 6-32 x ½" machine screws secure lid - into tapped holes.
  • Designed to meet IP54.
  • Low side wall draft angle (2 degrees or less) for easy P.C. board mounting.
  • Dimensions shown are exterior dimensions.

$21.69
Click to read more
P-H551Switch - Carling, Footswitch, SPST, Off-(On), Screw Terminals

Carling, SPST footswitch, Off-(On), momentary, normally open with screw terminals. Note: Off-(On) switches may sometimes be referred to as Off-None-(On).


$6.95
$4.06
You save: 42%
Click to read more
K-998Effects Pedal Kit - MOD® Kits, Tone Attack, Active Tone Stack

Shape your sound with the Tone Attack. 12 o'clock settings give an approximate unity gain with the pedal. Rotate the treble or bass knob counterclockwise to cut the corresponding frequencies. Rotate these same knobs clockwise to boost the frequency bands. The master boost knob can be used to attenuate your signal or push your tone to screaming loud volumes. MOD® Kits are designed to give both novice and experienced musicians the opportunity to build their own amps and effects pedals. All kits come with easy to follow instructions and use point to point wiring. Pre-drilled enclosure and all parts are included. All you need to provide are hand tools, a soldering iron and solder. The Tone Attack operates on a 9V battery or AC adapter, which is not included. The Godlyke 9-volt adapter (M-PAS-S) may be purchased separately to power your new pedal.


$64.95
Click to read more
M-OD808Effects Pedal - Maxon, OD808, Overdrive

The Original Overdrive! The OD808 is often imitated but never matched! Identical to the 1970s circuit and featuring the JRC4558 IC chip, it offers warm, smooth, transparent overdrive that'll make your rig scream! The OD808's dynamically responsive circuitry reacts precisely to individual playing styles, letting the true voice of any instrument or artist shine through. Don't settle for copies when you can have the original. The OD808 Reissue offers up all the warm, creamy, organic overdrive as the original and then some. Never one to rest on their laurels, Maxon has tweaked the current version ever so slightly to reduce noise level while retaining the legendary “808" tone. The OD808 is the perfect pedal for adding smooth, tube-like overdrive to any clean amp – use it as a secondary dirt channel to beef up a song's chorus section, or keep it on all the time for the crunchy tone that has defined rock and roll.


$149.00
Click to read more
R-V250KJ-SSPotentiometer - Fender®, 250kΩ, J Taper, Solid Shaft, Control

Original Fender solid shaft 250K potentiometer with J taper. 3/8-32 threading. The resistance between wiper and cold lug measures about 25% at half-way shaft rotation.


$7.50
Click to read more

Pages

(14 pages)
Don't see a product you're looking for? Send us your product suggestions!
Subscribe to RSS - Effect Pedals & Parts