You are here

Effect Pedals & Parts

Adding effects to your signal path is a great way to alter the sound of your guitar. Add reverb, delay, distortion, frequency ranges and other dynamic effects.

Build a kit or purchase parts to make your own!

Filter these results
Sort By:
products per page
View Mode: List View · Grid View

Pages

(13 pages)
K-956Effects Pedal Kit - MOD® Kits, The Thunderdrive Deluxe LTD, Overdrive

The Thunderdrive Deluxe LTD is an overdrive pedal kit that will provide a strong clean signal boost in the early gain settings and smooth distortion at maximum gain settings. Adjusting output and distortion controls provides a wide variety of tones in spite of its simple construction. It is capable of overdriving the preamp section of your guitar amp or adding its own layer of distortion at lower volume. This version is equipped with a three position diode selector switch.



The switch offers three different settings and tones. The top position is the classic silicon clipping diodes used in the original Thunderdrive. The middle position gives you the lifted diode "turbo" sound from the Deluxe model. The bottom position is a new setting limited to this version using germanium diodes for a warm vintage distortion.


$49.95
Click to read more
K-998Effects Pedal Kit - MOD® Kits, Tone Attack, Active Tone Stack

Shape your sound with the Tone Attack. 12 o'clock settings give an approximate unity gain with the pedal. Rotate the treble or bass knob counterclockwise to cut the corresponding frequencies. Rotate these same knobs clockwise to boost the frequency bands. The master boost knob can be used to attenuate your signal or push your tone to screaming loud volumes. MOD® Kits are designed to give both novice and experienced musicians the opportunity to build their own amps and effects pedals. All kits come with easy to follow instructions and use point to point wiring. Pre-drilled enclosure and all parts are included. All you need to provide are hand tools, a soldering iron and solder. The Tone Attack operates on a 9V battery or AC adapter, which is not included. The Godlyke 9-volt adapter (M-PAS-S) may be purchased separately to power your new pedal.


$64.95
Click to read more
K-997Effects Pedal Kit - MOD® Kits, Erratic Clutch Deluxe, Fuzz/Divider

The Erratic Clutch Deluxe is a unique effect pedal kit that gives you fuzzy square wave distortion as well as a monophonic sub-octave square wave using a total of only four transistors. The two signals can be used individually or mixed together for a raw and sonically rich synthy output. Full of character and quirk, this pedal will give you a truly original sound. The middle knob is the bias control. This adjusts the pulse width in the initial fuzz stage of the pedal. Set this knob to fit your pickups and playing style. The closer to the center the longer the note will sustain but with that comes more chaotic tracking for the divider. Moving it more clockwise or counterclockwise will give you more predictable note tracking on the divider with less sustain.


$69.95
Click to read more
K-996Effects Pedal Kit - MOD® Kits, The Penetrator, Treble Boost

The Penetrator is a treble boost pedal kit with enough gain to cut straight through any mix. This pedal adds glistening harmonics that get loud enough to saturate your amp’s front end. Adjust the level knob to vary the output so there’s no mistaking when you kick this pedal in. Great for solos or when you need your guitar front and center.


$38.95
Click to read more
K-991Effects Pedal Kit - MOD® Kits, The Rock Bottom, Bass Fuzz

The Rock Bottom is a bass fuzz kit that gives you all of the sizzle you'd expect from a vintage fuzz without sacrificing those low frequencies. Use the blend pot to set your fuzz levels and dial in the volume to get that sound you need. This versatile pedal can be used for the sludgiest bass tones to the cleanest boost and everything in-between.


$43.95
Click to read more
P-H590-XSwitch - Footswitch, 3PDT, LED Ring
Colors Available:

3PDT. LED ring requires a 3/4" mounting hole. Foot switch button set screw requires 1.5mm hex key.


Starting at $7.95
Click to read more
K-P155Battery Clip - 9 Volt with Vinyl Tab

Single standard snap-on 9V battery clip. Features six inch pre-stripped and pre-tinned leads for an easy connection.


$0.60
Click to read more
P-L700-XLED - 5mm, Water Clear, High Brightness, Package of 5 (Package of 5)
Colors Available:

High brightness 5mm LED. Great for use in pedal and amp builds as well as other applications where a bold, bright, indicator is needed. Multiple colors available.



  • 5mm size
  • Water clear
  • High brightness
  • Multiple colors available
  • Package of 5

Starting at $1.30
Click to read more
P-L600-XLED - 3mm, Water Clear, High Brightness, Package of 5 (Package of 5)
Colors Available:

High brightness 3mm LED. Great for use in pedal builds and other applications where a bold, bright, indicator is needed. Multiple colors available.



  • 3mm size
  • Water clear
  • High brightness
  • Multiple colors available
  • Package of 5

Starting at $1.30
Click to read more
P-RBTSE-99FXDSP Module - Accutronics, 99 Effects (Reverb, Chorus, Delay, +)

The BTSE-99FX Effect board provides 99 different digital audio effects to be used in many audio applications that require sound enhancement. Equipped with a superb quality digital effects processing engine which adds that extra punch needed to make sounds truly stand out. Applications:



  • Guitar/ Keyboard/Bass amplifiers and combos
  • Audio mixing consoles / Powered mixing consoles
  • Stand -alone stereo effect units for studio and PA usage
  • Effects pedals

$32.00
Click to read more

Pages

(13 pages)
Don't see a product you're looking for? Send us your product suggestions!
Subscribe to RSS - Effect Pedals & Parts