You are here

Effect Pedals & Parts

Filter these results
Sort By:
products per page
View Mode: List View · Grid View

Pages

(13 pages)
P-ECB-255Potentiometer - Dunlop, 470K for JH-F1 Jimi Hendrix Fuzzface
Genuine Dunlop replacement potentiometer for Jimi Hendrix JH-F1 Fuzz Face. 470K,Audio,solid plastic shaft. Made In U.K.
$4.95
Click to read more about this product.
P-ECB-31Felt Pad - Dunlop, for Wahs
$1.25
Click to read more about this product.
P-ECB-554Switch - Dunlop, MXR, DPDT, PC mount for Carbon Copy
Genuine Dunlop replacement foot switch for Carbon copy delay. DPDT, PC Mount.
$5.50
Click to read more about this product.
P-ECB-590Screws - Dunlop, MXR, housing screws, package of 4
Genuine Dunlop replacement housing screws for MXR/ Dunlop pedals. Replace lost screws and keep your battery access plate on tight. 6-32 thread, Phillips head.
$1.25
Click to read more about this product.
P-ECB-67Knob - Dunlop, MXR, small knurled, aluminum
Genuine Dunlop replacement small knurled knob for MXR pedals. Push -on style knob designed for use with knurled shafts.
$2.25
Click to read more about this product.
P-ECB-78Potentiometer - Dunlop, 10K linear
Genuine Dunlop replacement potentiometer for wah/volume.
  • 10K Linear
  • Gear included
$12.00
Click to read more about this product.
P-L500Bezel with LED Lamp - 5mm, Red with holder
5 mm diameter Red LED with holder. Perfect for amps and effects. Mounts in a 5/16" diameter chassis hole.
$0.95
Click to read more about this product.
S-HLW-CARLINGLocking Washer - Carling (Package of 5)
Flat washer/locking ring. Fits switches that mount to 1/2" chassis holes. A 0.110" length guide tab ensures a locking fit (locking hole is 0.376" from chassis hole center).
$1.50
Click to read more about this product.
M-PAS-BKit - Power All System Basic, For Effects Pedals

The Power-All PA-9 Digital Power Supply is the world’s first 2000 mA, single outlet power supply designed specifically for guitar effect users. Don’t waste money on batteries or take up valuable space with multiple “wall wart” adaptors or power bricks – the Power-All system can power your entire pedalboard from a single power supply that takes up only one outlet! The Power-All provides 9 volts DC at 2000 milliamps – more than enough current to power dozens of effect pedals, including up to four Line 6 Modelers! The Power-All’s special circuit design offers the lowest noise floor of any digital power supply on the market. The PA-9 now comes with a ferrite-core filter built onto its output cable to further reduce noise and hum.


$24.00
Click to read more about this product.
M-PAS-CABLE-6Cable - For Power All Systems, C-GY
Included in the PA-9 Power-All System and also sold separately, the Cable-Grey allows the user to power vintage and boutique effect units that run off 9-volt batteries but do not have an external AC power jack.
The Cable-Grey hooks directly to the unit's Battery Snap and can be connected to any of the Power-All daisy chains, or directly to the Power-All.
Cable-Grey is 158.75 mm (approximately 5.25 inches) in length from plug to plug.
NOTE: The Power-All Cable-Grey was designed to hook directly to the battery snap inside a pedal and then provide power to the pedal using an external DC power adaptor.
The wiring of the Cable-Grey’s battery snap is the OPPOSITE of what would normally be needed to connect to a 9-Volt battery.
$2.95
Click to read more about this product.

Pages

(13 pages)
Subscribe to RSS - Effect Pedals & Parts