A must for anyone out there with Pre-CBS Fender® guitars and basses. Look no further. You can finally replace those old rusty, stripped out screws with correct new ones that look and are just like the originals. We went to special efforts to have these rare and unusual screws made for use specially, so you can keep that vintage Fender® in primo condition. This assortment contains 595 pieces and comes with a traditional, free, pre-labeled cabinet for easy access and reordering. This Kit contains:
Marshall toggle switch, latching 2 position DPST, On-Off. 15A 250VAC rating. Used for Mains and Standby switch in Marshall 1959SLP, 1987X, 2245 and others. See Marshall nut S-HM300N if necessary. Nut sold separately. Note: On-Off switches may sometimes be referred to as On-None-Off.
Set of 13 phillips head screws for Leslies. Includes 13 flat washers. 13 pieces replaces all of the screws on the upper cover, lower cover and middle back panel.
Original Fender speaker mounting stud/nut set. These speaker mounting studs were used on countless amps of the '50s, '60s, '70s, and beyond. The reverse thread section screws into the baffle wood and the machine screw section holds the speaker in place using the included keps nuts.
Vulcanized Cellulose Fiber for all electrical insulation. Gray insulating paper. .010" thick. used in switches, under terminals, in transformers, etc .where mechanical strength is required. Its qualities of toughness, flexibility, and edge-tearing resistance combined with high dielectric strength and ready absorption of insulating varnish have led to its predominant use as an improved motor slot call insulation. Dielectric strength 3000 volts. 10" wide roll contains 240 sq. inches.
480.820.5411