You are here

New Products

Filter these results
Sort By:
products per page
View Mode: List View · Grid View


(7 pages)
P-BAS-H492-SL-UBaseplate - Humbucker, 49.2mm, Universal, USA

Original, made in USA, humbucker frame with universal holes for multiple configurations. This premium baseplate has a 49.2mm spacing and is made of raw nickel silver.

On Backorder
Click to read more
C-EC30-20-475Capacitor - CE Mfg., 475V, 30/20µF, Electrolytic

CE Manufacturing USA Made Multi Section Can Capacitor. Reproduced To Exact Mallory Specs Using Original Mallory Machinery. The C-EC30-20-475 is a great replacement for the original can capacitors found in H.H. Scott 299 amplifiers as well as others.

Click to read more
C-ETX-50-ILCapacitor - Illinois, 50V, Axial Lead Electrolytic

High quality low leakage tubular electrolytic capacitor. Rated for 85° C operation. Tolerance -20%, +50%. Axial leads. Rated for 50V max.

Starting at $0.33
Click to read more
Choke - Hammond, replacement for Vox TB35C2

16H @ 40 mA guitar amplifier replacement for Vox TB35C2 Tony Bruno. Physically, parts were designed to look similar to original factory units (where possible). Material used & design specs. were kept as close as possible to the original part to preserve the stock "tone".

Click to read more
P-Q1N5817Diode - 1N5817, Schottky, High Switching Speed

Schottky diode with low forward voltage drop and high switching speeds.

Click to read more
B-980Fundamentals of Guitar Amplifier: System Design by Richard Kuehnel

Books about guitar amplifier electronics usually focus on individual circuits: preamp stages, tone stacks, phase inverters, the power amp, and power supply. Fundamentals of Guitar Amplifier System Design presents a structured, top-down approach to crafting a complete guitar amplifier.

Click to read more
S-G507Grill Cloth - Oxblood, 36" Wide
Sold by the yard
Click to read more
P-BAR-H492-U-10Keeper Bar - 10 Hole, 49.2mm, Raw Steel, USA

Original, made in USA, 10-hole keeper bar for 49.2mm spacing. This P.A.F. correct keeper bar is great for humbucker and P-90 pickups. Made of raw steel.

Click to read more
P-LRING-XLED - Footswitch Ring, With Bezel, 9V
Colors Available:

Leaded LED rings for use with standard footswitches.These LED rings use an array of LED's with internal current limiting so no additional parts are required for use with 9VDC. Red, green, blue, and two-color combinations are available. A 15mm panel hole is required. See full dimensions below to check footswitch compatibility.

Starting at $1.50
Click to read more
P-MB-1-XMagnet - Bar, Alnico, Cast, 2.444"

Alnico cast bar magnets for use in humbucker and P-90 pickups. These are fully magnetized through the width and measure 2.444” x .5” x .125”.

Starting at $2.25
Click to read more


(7 pages)