You are here

Pedal Parts / DIY

Filter these results
Sort By:
products per page
View Mode: List View · Grid View

Pages

(34 pages)
P-Q972Diode - 1N34A Germanium, low leakage

The 1N34A Germanium diode is an old standby in electronics. Widely used for detecting the rectifying efficiency or for switching on a radio, TV or stereo etc.


$1.75
Click to read more
P-QBA4560Op-Amp - BA4560, Dual, General Purpose, 8-Pin DIP

The BA4560, is a dual operational amplifiers which achieves approximately twice the high output current of the BA4558, as well as featuring a higher slew rate of 4V / µs, a gain band width of 10MHz, and an improved frequency characteristic. 8-pin DIP package.


$0.95
Click to read more
P-QM5201Op-Amp - M5201, Dual, With Switch, 8-Pin DIP

The NJM2120 is a dual operational amplifier of 2-INPUT and 1-OUTPUT with analog switch. The NJM2120 can be used as analog switch under the condition of GV=0dB, as Switch + Amp in order that each gain (A or B) can be adjusted independently. Each amplifier of the NJM2120 has the same electrical characteristics as the NJM4558. The NJM2120 is suitable for audio, video, electrical musical instrument, etc.


$4.50
Click to read more
P-QMC78L05Regulator - 5 Volt, Linear Voltage Regulator

5V Linear Regulator. Used in MOD® kits. This fixed-voltage monolithic integrated circuit voltage regulator is suitable for applications that required supply current up to 100 mA.


$0.50
Click to read more
P-QNE5532Op-Amp - NE5532, Dual, Low-Noise, 8-Pin DIP

This a high performance dual low noise operational amplifier. Compared to the standard dual operational amplifiers, such as the NJM1458, it shows better noise performance, improved output drive capability, and considerably higher small-signal and power bandwidths. it is compensated internally for voltage follower circuit. This makes the device especially suitable for application in high quality and professional audio equipment, instrumentation, control circuits, and telephone channel amplifiers Features:



  • Operating Voltage = ±3V~±22V
  • Small Signal Bandwidth = 10MHz typ.
  • Output Drive Capability = 600Ω,10Vrms typ.
  • Input Noise Voltage = 5nV/√Hz typ.
  • Power Bandwidth = 140kHz typ.
  • Slew Rate = 8V/µs typ.
  • Bipolar Technology

$1.15
Click to read more
P-QTL072Op-Amp - TL072, Dual, Low-Noise, JFET Input, 8-Pin DIP

The TL072 is a high speed JFET input dual operational amplifier incorporating well matched, high voltage JFET and bipolar transistors in a monolithic integrated circuit. The device features high slew rates, low input bias and offset current, and low offset voltage temperature coefficient.


$0.70
Click to read more
P-QTL074Op-Amp - TL074, Quad, Low-Noise, JFET Input, 14-Pin DIP

Low noise JFET quad operational amplifier. Incorporates well matched, high-voltage JFET and bipolar transistors in a monolithic integrated circuit. Features high slew rates, low input bias and offset currents, and low offset voltage temperature coefficients. Features:



  • Wide common-mode and differential voltage range
  • Low input bias and offset current
  • Low noise en = 15 nV/HZ
  • Output short-circuit protection
  • High input impedance JFET input stage
  • Low harmonic distortion: 0.01%
  • Internal frequency compensation
  • Latch up free operation
  • High slew rate: 16 V/us (typical)

$1.15
Click to read more
P-RBTDR-1H-XReverb Module - Accutronics Belton, Digi-Log, horizontal mount

A great digital reverb sound that easily replaces a spring reverberation unit. Simple interface requires only input, output, +5V, and ground. Output requires no external capacitors.


Starting at $12.95
Click to read more
R-VAM300KLPotentiometer - Alpha, 300kΩ, Linear, Knurled Shaft, 16mm

Miniature Alpha pot for guitars. 300K linear taper.


$1.50
Click to read more
R-VAMXAPotentiometer - Alpha, Audio, Knurled Shaft, 16mm

Miniature Alpha pot for guitars. Audio taper.


$1.50
Click to read more

Pages

(34 pages)
Don't see a product you're looking for? Send us your product suggestions!
Subscribe to RSS - Pedal Parts / DIY