Pedal Parts / DIY

Switch - Carling, Mini Toggle, SPDT, 3 Position, Solder Lugs, Short Bat
Carling, SPDT mini toggle with short actuator, 3 positions, ¼" mounting hole diameter, 0.354" bushing length.
  • 0.354" bushing length
  • 3-Position On/Off/On
  • ¼" mounting hole diameter
  • Single pole/Double throw (SPDT)
  • Solder lugs
$3.95
LED Bezel - for 3mm LED, used for mounting
Holder for mounting LEDs to panels.
$0.95
Transistor - AS194DE, Matched Pair, Alfa, SOIC-8, NPN
The AS194DE is a junction isolated ultra well-matched monolithic NPN transistor pair with an
order of magnitude improvement in matching over conventional transistor pairs. Electrical characteristics of these devices such as drift versus initial offset voltage, noise, and the exponential relationship of base-emitter voltage to collector current closely approach those of a theoretical transistor. Extrinsic base and emitter resistances are very low, giving very low noise and operating over a wide current range.
To guarantee long term stability of matching parameters, internal clamp diodes have been added across the emitter-base junction of each transistor. These prevent degradation due to reverse biased emitter current, the most common cause of field failures in matched devices.
$4.50
Screws - Dunlop, MXR, housing screws, package of 4
Package of 4
Genuine Dunlop replacement housing screws for MXR/ Dunlop pedals. Replace lost screws and keep your battery access plate on tight. 6-32 thread, Phillips head.
$1.55
Op-Amp - TL022, Dual, Low Power, 8-Pin DIP
TL022 dual op amp in an 8-pin DIP package. The TL022 is a dual low-power operational amplifier designed to replace higher power devices in many applications without sacrificing system performance. High input impedance, low supply currents, and low equivalent input noise voltage over a wide range of operating supply voltages result in an extremely versatile operational amplifier for use in a variety of analog applications including battery-operated circuits.
$0.69
¼" Jack - Pure Tone, Stereo, Double-Open Circuit, Long Thread
Pure Tone’s new long threaded three pole (stereo) 1/4" jack provides full contact for improved connections and signal integrity. This jack locks the cable securely into place creating a greater surface area connection to carry more signal for an improved frequency stability. This jack is a great choice for both mono and stereo applications as well as guitars using active electronics.
$9.99
Footswitch - 3PDT, Blue, PC Mount, latching-type
3PDT latching footswitch with PC terminals. Blue with 9 terminals. Made in Taiwan.
$5.95
Turret Strip - 13 Lugs, Single Row, U-style
Single row of 13 U-style terminals on a black board. The U-style terminal strips are spaced 8.3mm apart allowing for more densely populated point-to-point builds. The boards are 0.063” thick.
$1.39
Cable - Power All, Grey Battery Snap Jumper
Included in the PA-9ECB Basic Kit and also sold separately, the Cable-Grey allows the user to power vintage and boutique effect units that run off 9-volt batteries but do not have an external AC power jack. The Cable-Grey hooks directly to the unit's Battery Snap and can be connected to any of the Power-All daisy chains, or directly to the Power-All.
$2.95
Terminal Strip - 5 Lug, 3rd Lug Common, Horizontal
Package of 5
Standard size terminal strips, 1/16" thick bakelite, tin plated steel solder lugs and brackets on 3/8" centers.
$4.99
Knob - Rogan, PT Series, 1P, Small, Pointer, D-Shaft
High-quality USA made knobs from Rogan Corp. These small pointer knobs from Rogan’s PT Series feature a soft rubber grip molded over a solid polymer knob. PT Series knobs can be found on synthesizer modules from Make Noise, Mutable Instruments and others. Fits 6mm D-shafts.
  • Height: 0.55 in.
  • Diameter: 0.45 in.
  • Fits 6mm D Shafts
  • Indicator on round side of D-shaft

For a T18 knurled version of this knob, see P-K271P-W. A variety of different sizes are available from the PT Series.
$1.65
On Backorder
Diode - 1N5817, Schottky, High Switching Speed
Schottky diode with low forward voltage drop and high switching speeds.
$0.15
Knob - Large, Indicator Line, Set Screw
Colors Available:
Large, knob with line indicator and set screw similar in style to the Davies 1500 and 1510 knobs. Pairs well with P-K380X. Fits ¼” (6.35mm) pot shafts.
  • Knob Height = 0.60"
  • Pointer Diameter = 1.06"
  • Fits 1/4" shaft with set screw
  • Oversized Davies 1510 Clone
$1.05
StripBoard - Single Sided, 3.94” x 3.15”, Mounting Holes
ST2 StripBoard is a prototyping circuit board with a standard long strip pattern. Tracks run the length of the board. The long tracks are convenient for power and ground rails, and for signal buses. Strips can be cut as needed to make smaller tracks and circuit pads. It has 0.1" hole spacing for DIP integrated circuits and headers and other parts. ST2 has higher quality than traditional stripboard. The holes are drilled, not punched. The base material is high-quality FR4 glass epoxy board. It has better stability and moisture resistance than boards using phenolic or SRBP (synthetic resin bonded paper), which can warp with exposure to humidity. Features
  • Standard stripboard pattern, with tracks running the length of the board.
  • Single-sided high-quality FR4 glass-epoxy circuit board.
  • 1oz/ft2 copper with an anti-tarnish coating for easy soldering.
$4.75
¼" Jack - Switchcraft, Mono, shunt tip
Switchcraft Type 12A Littel-Jax shorting type phone jack. The switched terminal is normally closed and is usually connected to ground to eliminate hum when unplugged. Mono 2-conductor. Mates with standard ¼" plugs and is available with standard or long bushings. Includes nut and washer
Starting at $2.45
Finishing Nut - For ⅜” Jacks and Pots, ⅜”-32 UNEF-2A
Package of 5
Colors Available:
High quality plated ⅜” nuts for jacks and potentiometers. These nuts are perfect for amplifier, pedal and synthesizer builds with high aesthetics or color theming. The ⅜”-32 UNEF-2A threading fits many ⅜” bushing parts such as Switchcraft ¼” jacks and CTS pots.
Starting at $0.59
Capacitor - 500V, Ceramic Disc, ± 10%
Radial ceramic capacitor.
  • Voltage rating: 500VDC
  • Tolerance: ± 10%
Starting at $0.25
Integrated Circuit - AS571D, Compandor, Alfa, SOIC-16
The AS571D is Alfa’s version of the NE571 or SA571 in an SOIC package. AS571 is a versatile low cost dual gain control circuit in which either channel may be used as a dynamic range compressor or expandor. Each channel has a full-wave rectifier to detect the average value of the signal, a linearized temperature-compensated variable gain cell, and an operational amplifier. AS571 is well suited for use in VCA blocks, noise reduction systems, compandors/expanders ,etc. Features
  • Complete compressor and expandor
  • Temperature compensated
  • Channel separation >86 dB
  • Greater than 110 dB dynamic range
  • Levels adjustable with external components
  • Distortion may be trimmed out

Applications
  • VCA
  • High level limiter
  • Low level expandor − noise gate
  • Dynamic filters
  • Dynamic noise reduction systems
$5.50
¼" Jack - Rean, Mono, Open Circuit
2 pole open 1/4" jack, 2 contacts, with washer and nut, panel thickness 3.5 mm, with 0.205" faston tabs
Starting at $1.45
Chassis Box - Hammond, 1590E, Diecast, 7.40" x 4.72" x 3.07"
  • Rugged, diecast aluminum alloy (tough yet easy to machine), electronic instrument enclosure.
  • Lap joint construction provides protection against access of dust and splashing water. Also provides for improved EMI/RFI shielding.
  • Vibra finished for a smooth surface with no sharp edges.
  • Six 6-32 x ½" machine screws secure lid - into tapped holes.
  • Designed to meet IP54.
  • Low side wall draft angle (2 degrees or less) for easy P.C. board mounting.
  • Dimensions shown are exterior dimensions.
$23.91
Chassis Box - GØRVA Design, C65, Diecast, 4.72” x 2.56” x 1.54”
Colors Available:
The Gorva C65 is a high quality powder-coated take on the Hammond 125B size enclosure with a focus on function and design. Features:
  • Slightly beveled top and rounded corners for high quality look.
  • Tight fit and small gap between the enclosure and lid.
  • Undercut boss allows more internal room for more flexible layout.
  • Smooth, eggshell-like matte powder coating.
  • Recessed bottom lid
$14.95
Potentiometer - Wah replacement pot with gear
Standard vintage style wah pots with solder lugs and gear included. Part # R-VWAH-POT (100K) has an audio taper. All others are linear.
$5.95
Diode - 1N914, Small Signal
The 1N914 is a small signal diode similar to the 1N4148 and is common in many older electronics. The 1N914 is general purpose and can be used in a multitude of different applications.
$0.18
¼" Jack - Cliff, PC Mount, L-Leg
Input jack, 4 PC board terminals, switched, L-leg mounting. Low-noise Ni-Ag® Alloy Self-Cleaning Contacts for superior performance and reliability.
Starting at $2.79