Pedal Parts / DIY
Chassis Box - Hammond, 1590E, Diecast, 7.38" x 4.70" x 3.07"
- Rugged, diecast aluminum alloy (tough yet easy to machine), electronic instrument enclosure.
- Lap joint construction provides protection against access of dust and splashing water. Also provides for improved EMI/RFI shielding.
- Vibra finished for a smooth surface with no sharp edges.
- Six 6-32 x ½" machine screws secure lid - into tapped holes.
- Designed to meet IP54.
- Low side wall draft angle (2 degrees or less) for easy P.C. board mounting.
- Dimensions shown are exterior dimensions.
¼" Jack - Fender®, Mono, PC Mount, Closed Circuit
PCB mono closed circuit.
Transistor - 2N2222A, TO-18 case, NPN
The 2N2222A is a NPN transistor in a TO-18 metal case. The 2N2222A is commonly used in fuzz pedals.
Footswitch - DPDT, Momentary, PC Terminals
DPDT momentary footswitch with PC terminals. Black with 6 terminals. AC125V 4A, AC250V 2A. PC mount version of P-H503.
Wire - Bus, 100 foot Spool, tinned copper
Solid tinned copper bus wire. 105°C temperature rating, 600V.
Starting at $6.95
Chassis Box - Hammond, 1590TRPC, Diecast, Trapezoid, 3.74" x 6"Uniquely shaped trapezoid Hammond enclosure. Screws included.
¼" Jack - Rean, Mono, Horizontal, Switched, PC, Gold
2 pole horizontal 1/4" jack, all contacts switched, gold plated contacts, chrome ferrule nut
Potentiometer - Dunlop, 20 kΩ, Custom Taper, Wah Pot, for Bass
Custom taper 20k Dunlop potentiometer used in 105Q Crybaby Bass Wah. 1 million cycles, maintenance free.
Potentiometer - Alpha, 300kΩ, Linear, Knurled Shaft, 16mm
Miniature Alpha pot for guitars. 300K linear taper.
¼" Jack - Cliff, PC Mount, L-Leg
Input jack, 4 PC board terminals, switched, L-leg mounting. Low-noise Ni-Ag® Alloy Self-Cleaning Contacts for superior performance and reliability.
Starting at $2.10
Breadboard - Solderable PCB, 3.75” x 1.85”, Mounting Holes
Solderable PC BreadBoard enables you to transfer your circuit and wires from a plug-in breadboard without recutting wires or changing your layout. This breadboard has the same pattern as a standard 400 connection point solderless plug-in breadboard which has a standard 5-hole strip for each IC pin, just like solderless breadboards. However, it has the advantage that soldered joints provide a more reliable long-term connection than solderless contacts. The board has four power rails like solderless breadboards, plus two bonus rails for power or signals. There are bonus two-hole pads along the centerline allowing DIL (dual in-line) headers to be used as well as a top side silkscreen to position components. Four mounting holes allow your projects to be secured.