You are here

Potentiometers

Potentiometers are used to control volume and tone. A potentiometer is a three-terminal resistor with a sliding or rotating contact that forms an adjustable voltage divider.
Check out our Tech Corder articles on pots, including Potentiometer Types.

Filter these results
Sort By:
products per page
View Mode: List View · Grid View

Pages

(15 pages)
R-VPE500KASPL-1Potentiometer - PEC Guitar, 500kΩ, Audio, Long Bushing

Precision Electronic Components (PEC) Potentiometers are very high quality replacement and upgrade components. Hot molded Carbon element, gold-plated terminals, stainless steel shaft and housing. Mechanical rotation: 314° ¼" shaft diameter, 3/8" bushing diameter, 3/8" shaft length, ½" bushing length.


$44.95
Click to read more
R-VPV-10KA-100Potentiometer - Peavey, 10kΩ, Audio, Slide, 100mm

10K Audio, 100mm. Pin spacing: 4.870" x 0.191".


$7.50
Click to read more
R-VPV-20KL-SLDPotentiometer - Peavey, 20kΩ, Linear, Slide, 30mm

20K linear, 30mm.


$4.95
On Backorder
Click to read more
R-VSN-50KLD-DSPotentiometer - 50kΩ, Linear, D Shaft, 16mm, Snap-In, Detent

50KB Linear. Detent at 50% rotation. 16mm body size (mini type) Snap-In pot with mounting bracket. D-Shaft ¼", ½" length shaft. 7mm bushing, ¼" bushing length. PC Mount. Nut and washer included


$1.25
Click to read more
R-VB-XL-PPot - Bourns, Linear, Knurled Shaft

Potentiometer - Bourns, Linear Taper, Knurled Split Shaft, Premium


$9.95
$8.95
You save: 10%
Click to read more
R-VPSH-500KA-LPotentiometer - 500kΩ, Audio, Knurled Long, DPDT, Push-Push

DPDT switch, ¼" split knurled shaft, audio taper. 3/8-32 threads, 16mm body diameter. .75" bushing length, .38"-.52" shaft length.


$11.30
Click to read more
R-VSLD20KLPotentiometer - 20kΩ, Linear, Slide

20K linear slide potentiometer, center detent.


$0.40
$0.30
You save: 25%
Click to read more
R-VPSH-250KAPotentiometer - 250kΩ, Audio, Knurled Shaft, Push-Push, DPDT

DPDT switch, ¼" split knurled shaft, audio taper. 3/8-32 threads, 16mm body diameter. .40" bushing length, .38"-.52" shaft length.


$9.80
Click to read more
R-VPMT-DMTXPotentiometer - PMT, Dual Mode Tone Control

The DMT is a passive dual mode guitar tone control designed specifically for electric guitars that can operate in either HIGH PASS or LOW PASS modes greatly expanding the instruments tonal possibilities without the use of a battery or active electronics. Micro switches on the circuit board provide the user the ability to select one of two different frequency ranges for both high and low pass modes. Easy installation with no capacitors or other parts needed. Replace the tone control in you guitar with one that you will actually use!


Starting at $19.50
Click to read more
R-VPMT-HCPPotentiometer - PMT, Humbucker Control, Coil Filters

The HCP Humbucker Control Pot is a dual mode variable coil tap selector for electric guitars and basses that eliminates the additional switches associated with coil splitting a pair of humbuckers. In TAP mode, rotating the pot counterclockwise fades from humbuckers to outer coils (neck pickup South coil & bridge pickup North coil). Pulling the HCP control up and rotating it counterclockwise fades from humbuckers to inner coils (neck pickup North coil & bridge pickup South coil). Tonal control is expanded with the unique ability to coil tap both humbuckers in varying amounts. In COIL FILTER mode, turning the HCP control applies varying amounts of a specially tuned high frequency filter to only one coil of the selected coils of the humbuckers (either North or South coils can be filtered). This makes each pickup a single coil at high frequencies and a humbucker at lower frequencies which produces a sound similar to a pair of single coils but with a stronger, fuller tone and 50% less noise than coil tapping.


$22.75
Click to read more

Pages

(15 pages)
Don't see a product you're looking for? Send us your product suggestions!
Subscribe to RSS - Potentiometers