You are here

Potentiometers

Potentiometers are used to control volume and tone. A potentiometer is a three-terminal resistor with a sliding or rotating contact that forms an adjustable voltage divider.
Check out our Tech Corder articles on pots, including Potentiometer Types.

Filter these results
Sort By:
products per page
View Mode: List View · Grid View

Pages

(15 pages)
R-VB-CPSPPotentiometer - Bourns, Audio, Knurled Shaft, ⅜" Bushing
Bourns Audio Potentiometer, Vintage Premium, Conductive Polymer, Solder Lugs

  • 0.625" W x 0.377" L x 0.625" D
  • 300° rotation
  • Power Rating: ¼ watt
  • Tolerance: 10 %
  • ¼" Knurled 18-Spline Split Shaft
  • ⅜" Bushing Length
  • J Hooks
  • Specifically designed for vintage guitars
  • Very Low Noise
Starting at $16.00
Click to read more
R-VPMT-DMTXPotentiometer - PMT, Dual Mode Tone Control

The DMT is a passive dual mode guitar tone control designed specifically for electric guitars that can operate in either HIGH PASS or LOW PASS modes greatly expanding the instruments tonal possibilities without the use of a battery or active electronics. Micro switches on the circuit board provide the user the ability to select one of two different frequency ranges for both high and low pass modes. Easy installation with no capacitors or other parts needed. Replace the tone control in you guitar with one that you will actually use!


Starting at $19.50
Click to read more
P-ECB-24BPotentiometer - Dunlop, Hot Potz II Crybaby, 100 kΩ

Hot Potz II Crybaby Pot. for newer Crybaby models. Made by Beckman. 100 kΩ. Original Dunlop replacement part. The same tone and sweep characteristics as the original Cry Baby Hot Potz potentiometer with low wiper noise and extended life.


$20.59
Click to read more
R-VPEC-APotentiometer - Precision Electronics, Audio, Slotted Shaft

Audio, 28mm potentiometer with slotted solid shaft, made by Precision Electronics. 10% tolerance. 2 watts.


$20.95
Click to read more
R-VPEC-LPot - Precision Electronics, Linear, 28mm

Linear, 28mm potentiometer with slotted solid shaft, made by Precision Electronics. 10% tolerance. 2 watts.


$20.95
Click to read more
R-VPMT-HCPPotentiometer - PMT, Humbucker Control, Coil Filters

The HCP Humbucker Control Pot is a dual mode variable coil tap selector for electric guitars and basses that eliminates the additional switches associated with coil splitting a pair of humbuckers. In TAP mode, rotating the pot counterclockwise fades from humbuckers to outer coils (neck pickup South coil & bridge pickup North coil). Pulling the HCP control up and rotating it counterclockwise fades from humbuckers to inner coils (neck pickup North coil & bridge pickup South coil). Tonal control is expanded with the unique ability to coil tap both humbuckers in varying amounts. In COIL FILTER mode, turning the HCP control applies varying amounts of a specially tuned high frequency filter to only one coil of the selected coils of the humbuckers (either North or South coils can be filtered). This makes each pickup a single coil at high frequencies and a humbucker at lower frequencies which produces a sound similar to a pair of single coils but with a stronger, fuller tone and 50% less noise than coil tapping.


$22.75
Click to read more
P-ECB-24APotentiometer - Dunlop Hot Potz, 470 kΩ

Used in Jimi Hendrix's WAH and Dunlop volume pedal. 470 kΩ. Original Dunlop replacement part.


$22.95
Click to read more
P-ECB-24CPotentiometer - Dunlop, 20 kΩ, Custom Taper, Wah Pot, for Bass

Custom taper 20k Dunlop potentiometer used in 105Q Crybaby Bass Wah. 1 million cycles, maintenance free.


$22.95
Click to read more
R-VX-S1Potentiometer - Fender®, S-1, Knurled Shaft, 4PDT

The Fender® S-1™ switched pot is a stealthy way to mod a strat without drilling any extra holes. The switch can be configured for almost any configuration with its four double-throw poles. S-1™ pots use a 3/8” bushing.


$24.95
Click to read more
R-VPEXASS-1Potentiometer - PEC Guitar, Audio, Solid Shaft

Precision Electronic Components (PEC) Potentiometers are very high quality replacement and upgrade components. Hot molded Carbon element, gold-plated terminals, 24mm potentiometer with stainless steel slotted solid shaft and one piece brass housing. Mechanical rotation: 300°, ¼" shaft diameter, ⅜" bushing diameter, ⅜" shaft length, ¼" bushing length. 1 watt.


$29.95
Click to read more

Pages

(15 pages)
Don't see a product you're looking for? Send us your product suggestions!
Subscribe to RSS - Potentiometers