You are here

Power Supplies & Accessories

Filter these results
Sort By:
products per page
View Mode: List View · Grid View
S-W133Cord - Power, 18 AWG, 3 Conductor, Black, No IEC, 12 Feet
12 feet, bare end type SJT (replaces most US made amps)
$5.95
Click to read more
P-ECB-9V1ABattery Box - Gotoh, single, 9 volt
Single 9 volt battery box.
See P-ECB-9V1B for single battery box with removable adapter.
See P-ECB-9V2 for double battery box.
$13.95
Click to read more
P-ECB-9V2Battery Box - Gotoh, Dual, 9 Volt
Dual 9 volt battery box. Two 9V battery compartments, each compartment having its own red and black wires for battery positive and negative connections (4 wires total) allowing for series, parallel or separate connections of two 9V batteries.
Four wood screws included.
Directions:
1. Refer to the Drawing B and make a hole on guitar body. 57.5 mm (2.26") x 49.5 mm (1.95"), R6 (6 mm = 0.24")
2. Put the box in guitar body and fix it by screws.
$19.00
Click to read more
P-SP2-K-003Receptacle - Interlock, Polarized
Package of 10

AC LINE INTERLOCK 11/4 mounting centers. polarized


$1.90
Click to read more
P-G00XGrommet - Rubber for chassis
Package of 5

Listed diameter is inside diameter. Sold in packs of 5. Multiple options available.


Starting at $0.95
Click to read more
M-PAS-CABLE-6Cable - Power All, Grey Battery Snap Jumper

Included in the PA-9 Power-All System and also sold separately, the Cable-Grey allows the user to power vintage and boutique effect units that run off 9-volt batteries but do not have an external AC power jack. The Cable-Grey hooks directly to the unit's Battery Snap and can be connected to any of the Power-All daisy chains, or directly to the Power-All.


$3.00
Click to read more
M-PP100Attenuator - Recycled Sound, Power Plug 100, -10 db to -30dB

The Power Plug 100 offers the same -10db as the Power Plug Lite (M-PPLITE) but adds another "Bedroom Level" pot for further attenuation of up to -30db AND is suitable for amps up to 100 watts! Turn your tube amp UP to drive your power tubes. This is where tube amps blossom and where players get in trouble. Use the attenuator to drop your overall volume to more tolerable levels. You can dial in your breakup, which may be too loud, then attenuate to lower the overall volume. So you can adjust your amp as usual and use the attenuator as an overall Master volume.


$189.95
Click to read more
P-H217PCB - Marshall, Valve PCB TSL100/TSL122, Rev 20

Marshall PC Board for TSL 100 / 122. Rev 20. Marshall Part: M-TL10-60-02-01


$236.25
Click to read more
M-PPLITEAttenuator - Recycled Sound, Power Plug Lite, -2 to -10dB

The Power Plug Lite offers up to -10db attenuation in a rotary switch with -2db increments. The Power Plug Lite will accept all impedances and is rated for up to 50 watt amps. The same cool extruded aluminum case as the original Power Plug (M-ATT-6-12) for those who want a lighter touch and more control. Turn your tube amp UP to drive your power tubes. This is where tube amps blossom and where players get in trouble. Use the attenuator to drop your overall volume to more tolerable levels. You can dial in your breakup, which may be too loud, then attenuate to lower the overall volume.


$114.95
Click to read more
P-H214Power Board Kit - Marshall, For AVT Series
Marshall replacement power board.

Works in the following models:
  • AVT50
  • AVT100
  • AVT150H
  • AVT150
  • AVT275
  • AVT275X
$66.60
Click to read more
Don't see a product you're looking for? Send us your product suggestions!
Subscribe to RSS - Power Supplies & Accessories