You are here

Power Supplies & Accessories

Filter these results
Sort By:
products per page
View Mode: List View · Grid View
P-HLOBATLow Battery Indicator - PMT, LoBat, for Active Electronics

The LoBat™ low battery indicator circuit is designed for use in electric guitars and basses with active pickups and electronics that use 9 volt batteries. Lights when battery voltage is below 7.7V. This early warning notifies the player it's time for a new battery days before tone begins to suffer!


$19.95
Click to read more
M-K080Power Supply - Korg, 12V, 1500mA, Center Positive
Korg Power Supply, KA-310 adapter for X50, MicroX, R3, MR1000, or SP170.
Please note that this requires an AC power cord to make it useable. We sell this cord and the part number is S-W128.
$34.95
Click to read more
M-PP100Attenuator - Recycled Sound, Power Plug 100, -10 dB to -30dB
The Power Plug 100 offers the same -10db as the Power Plug Lite (M-PPLITE) but adds another "Bedroom Level" pot for further attenuation of up to -30dB AND is suitable for amps up to 100 watts! Turn your tube amp UP to drive your power tubes. This is where tube amps blossom and where players get in trouble. Use the attenuator to drop your overall volume to more tolerable levels. You can dial in your breakup, which may be too loud, then attenuate to lower the overall volume. So you can adjust your amp as usual and use the attenuator as an overall Master volume.
$189.95
Click to read more
M-PAS-CABLE-5Cable - Power All, Green Right Angle Line-6 Extension Jumper

Included in the Power-All system and also sold separately, the Cable-Green Right Angle jumper allows the user to power Line-6 Stomp-Box modelers and other digital effect units from the PA-9. The Cable-Green features a reverse-polarity (tip positive), right-angle male barrel connector with a larger, 2.5 mm internal diameter and spring-loaded clips.


$3.00
Click to read more
M-ATT-6-12-XAttenuator - Recycled Sound, Power Plug 6 / 12, -6dB or -12dB
The Power Plug 6 / 12 attenuator is a "must have" device for anyone that plays a tube amp. If you want to work your power tubes without ear-splitting volume, you need an attenuator. The Power Plug is the BEST attenuator made for amps 50 watts and less. Simple 2 switch operation for -6db or -12db attenuation. Get your best tone!

Why 6/12? Engage 1 switch and remove -6db of power. Engage the 2nd switch and you're -12db. That's a volume reduction of 60%. The Recycled Sound attenuator is a passive, resistive load with compensated impedance and EQ, which maintains the designated impedance, EQ'd such that no degradation in tone is noted, even at full -12db attenuation. Use it as a Master Volume, use it to save your hearing at practice, find your tube tone without getting thrown out of the club, use it to prevent blowing up your vintage or low power speakers.

Use TWO in series and achieve -24db attenuation - bedroom level!
$89.95
Click to read more
M-K040Power Supply - Korg, 12V, 1500mA, Center Negative

For use with KP-1, X5D, X5DR, SP100, KAOSSPAD and 05R/W.


$33.95
Click to read more
M-PPLITEAttenuator - Recycled Sound, Power Plug Lite, -2 dB to -10 dB

The Power Plug Lite offers up to -10db attenuation in a rotary switch with -2db increments. The Power Plug Lite will accept all impedances and is rated for up to 50 watt amps. The same cool extruded aluminum case as the original Power Plug (M-ATT-6-12) for those who want a lighter touch and more control. Turn your tube amp UP to drive your power tubes. This is where tube amps blossom and where players get in trouble. Use the attenuator to drop your overall volume to more tolerable levels. You can dial in your breakup, which may be too loud, then attenuate to lower the overall volume.


$114.95
Click to read more
P-H1200Strain Relief - for ¾" x 27/32" hole, 5/16" cord diameter
16/3 SJT, 5/16" cord diameter. These one piece Strain Relief Bushings securely anchor, absorb, and protect cables and wires from push/pull and twist forces, while insulating them from irregular or sharp panel edges. They are easily and quickly installed with special installation pliers or other hand or production tools. Black H.S. Nylon, and the temperature index is 105° Centigrade.
$0.85
Click to read more
P-SP2-106Receptacle - for power cord
For connecting a detachable power cord to your amp.
$1.75
Click to read more
S-H201Fuse Holder - for Fender®, 3AG-Type

High quality Fender® Style fuse holder replacement for guitar amplifiers.



  • Fits ½" chassis hole diameter
  • Mounted by Nut

$1.95
Click to read more
Don't see a product you're looking for? Send us your product suggestions!
Subscribe to RSS - Power Supplies & Accessories