Radio & Antique Equipment Parts
Power Supply - Power All System, 9V, 2000mA, for Effects Pedals
The PA-9 Power-All is the world's first 2000 mA, single outlet power supply designed specifically for guitar effect users. Don't waste money on batteries or take up valuable space with multiple "wall wart" adaptors or power bricks - the Power-All system can power your entire pedalboard from a single power supply that takes up only one outlet! The Power-All's special circuit design offers the lowest noise floor of any digital power supply on the market. The PA-9S now comes with a ferrite-core filter built onto its output cable to further reduce noise and hum.
Alignment Kit - GC Electronics, for CB
Package of 8Contains
- 5009 Duplex no-metal screwdriver
- 5097 K-tran tool
- 8271 core aligner
- 8282 Zenith alignment tool
- 9091 hex iron core tool
- 9440 transistor tool
- 8276 Duplex aligner
- 9304 double end tool
Cable - Power All, 5 Lead Right Angle Daisy Chain
Right Angle Daisy Chain connector with standard polarity tip negative/barrel positive plugs connects the PA-9 Power-All to five effect pedals. The Cable-5/R can also be used with Power-All jumper cables to power effects that use different style jacks (reverse polarity, phone plug, battery clip, etc.). You can also link multiple Cable-5/R connectors to power over twenty 9-volt effect pedals or similar devices
O-Ring - Leslie, Rim Drive for Large Pulley
Replacement rubber O ring for the Leslie 122 and 147 cabinets.
Belt - Leslie, Upper Drive, 25.5", for 122/147, Polyurethane
Replacement upper drive belt for Leslie models 122 and 147. This belt is made of a high quality clear polyurethane that is both chemical and abrasion resistant ensuring a long life of use. This round belt had a 25.5 in. diameter with a sanded seam to ensure a smooth drive.
Aligner tool - GC Electronics, Duplex
Butyrate shaft 6-1/8" long with 1/8" wide steel tips. Tip on one end recessed.
- Material: Conductive Nylon Metal
- End: 1/8"
- End 2: 1/8"
Plug Cover Kit - Leslie, for Connectors
Plug cover kit for Leslie , screws included. This is the connector cap for the connecting cable.
Power Supply - Power All System, For Effects Pedals
The Power-All PA-9 Digital Power Supply is the world’s first 2,000 mA, single outlet power supply designed specifically for guitar effect users. Don’t waste money on batteries or take up valuable space with multiple “wall wart” adaptors or power bricks – the Power-All system can power your entire pedalboard from a single power supply that takes up only one outlet! The Power-All provides 9 volts DC at 2,000 milliamps – more than enough current to power dozens of effect pedals, including up to four Line 6 Modelers! The Power-All’s special circuit design offers the lowest noise floor of any digital power supply on the market. The PA-9 now comes with a ferrite-core filter built onto its output cable to further reduce noise and hum.
Starting at $24.95
Rotor Cover - 17", for Leslie 122/147
17" rotor cover fits Leslie models 122/147.
Motor Assembly - Upper Slow, for Leslie 122/147
Replacement upper slow motor assembly for Leslie models 122/147. Overall shaft length is 2.75".
Decal - Emerson, multiple logos for use on Emerson radios
Water slide decal (not a sticker). Emerson treble-clef logo is gold with black outline, in 2 common sizes.
Cable - Power All, Blue Right Angle Phone Plug Extension Jumper
Included in the Power-All System and also sold separately, the Cable-Blue/R features a right-angle jack that allows users to power effect units that use a 1/8" (3.5 MM) phone plug connector with tip-positive polarity. The Cable-Blue/R can be connected to any male jack on the Cable-5 Daisy Chain, or directly to the PA-9 itself.
Spring - Leslie, Tension, for Upper Belt
Replacement upper belt tension spring for Leslies.
Plug - for Leslie, 6 Pin Male, wavy washer
6 pin male plug with wavy washer, for Leslies.
Motor Assembly - Lower Slow, for Leslie 122/147
Replacement lower slow motor assembly for Leslie models 122/147. Overall shaft length is 2.75".
Switch - for Run Circuit in Hammond Organ
Switch for run circuit in Hammond Organ. Electrical Rating: 16 A - 125 V 8 A - 250 V Dimensions: Mounting Diameter: ½" Bushing Length: 0.425" Length: 1.89" Width: 0.82" Depth: 0.69"
Cable - Power All, Black Right Angle Extension Jumper
Included in the Power-All System and also sold separately, the Cable-Black/R allows the user to power over-sized effect units or units w/AC jacks in hard-to-reach places off of the Power-All Daisy Chain. The Cable-Black can be connected to any plug on any Power-All daisy chain, or directly to the PA-9 itself.
Bearing - Leslie, Upper Tension Idler
Sealed upper tension idler bearing for Leslies
Vibrator - 12 Volt, 3 Pin, Negative Ground
New manufacture solid-state replacements for 12 volt, 3 pin vibrators with a negative ground. These replace our old line of solid state vibrators. 1 1/2 dia. x 2 ¾" high aluminum can. Replace your buffer capacitor when you replace your vibrator!
Plastic Polish - Novus #3, heavy scratch remover
Removes scratches from acrylic surfaces; significantly reduces haziness. More abrasive than Novus #2 and is effective for deeper scratches. Treatment should be followed by Novus #2 to buff and polish surface.
Starting at $4.95
Relay - SPDT, Leslie 122 Retrofit
Reliable replacement relay for the Leslie 122. The small size makes this high quality relay easy to retrofit in the 122. Its performance exceeds the original relays used in the Leslie 122 with its very low switching noise and high ratings on both the contacts and the coil.
- 8 mm, 6 kV (1.2/50 µs) isolation, coil-contacts
- Coil EMC suppression
- Cadmium Free contact material
Power Supply - Dunlop, 9V, 200mA, Barrel, Center Negative
Dunlop ECB003 US wallwart power supply. Barrel connector.
Dunlop ECB003 US wallwart power supply. Barrel connector.
- Voltage: 9VDC
- Current: 200mA
- Tip Negative; Sleeve positive
Cable - Power All, Red Right Angle Reverse Polarity Jumper
Included in the Power-All System and also available separately, the Cable-Red/R allows the user to power effect units that have reverse polarity barrel connectors (tip positive/barrel negative). The Cable-Red/R features a tip positive, male barrel connector that is spring-loaded to prevent disconnection. The Cable-Red/R can be hooked to any plug on any of the Power-All daisy chains, or directly to the Power-All.
Transformer - Hammond, Radiola III-A Replacement Audio
Developed in response to requests from RCA Radiola III-A collectors. The original transformers are usually found with open" windings due to the fine wire and high turns usedcoupled with age. This is a universal replacement type - it will replace any of the three audio transformers used (1st audio driver2nd audio-phase splitter stage or output transformer)by correctly connectiong the 5 lugs. A pin out and connection diagram is included. The cases from the old transformer will fit this new unit. The terminal board is a duplicate of the original.
- Primary: 4000 turns, #41 wire (lugs 4 & 2)
- Secondary: 12000 turns C.T., #41 wire (lugs 5 & 1lug 3 is C.T. connection)
- Termination: Solder lugs on a 1 3/4" x 1" terminal board with 4-5" connecting leads
- Size: 1-7/8" long x 1-11/16" wide x 1-3/8" deep
- Lamination Core Size: 5/8" x 1/2"
- Weight: 7 oz.