Radio & Antique Equipment Parts

Relay - SPDT, Leslie 147 Retrofit
Reliable replacement relay for the Leslie 147. The small size makes this high quality relay easy to retrofit in the 147. Its performance exceeds the original relays used in the Leslie 147 with its very low switching noise and high ratings on both the contacts and the coil. Features:
  • 8 mm, 6 kV (1.2/50 µs) isolation, coil-contacts
  • Coil EMC suppression
  • Cadmium Free contact material
$32.50
Belt - Leslie, 31", Lower Drive, for 122/147, Polyurethane
Replacement lower drive belt for Leslie models 122 and 147. This belt is made of a high quality clear polyurethane that is both chemical and abrasion resistant ensuring a long life of use. This round belt had a 31 in. diameter with a sanded seam to ensure a smooth drive.
$16.95
Washer - Rubber, Chassis Mount, 1-⅛" x ¼" Thick
Gum rubber chassis mounting washers as used on thirties vintage Zenith and Philco radio. 1/4 inner dia. Allows proper dial centering in cabinet opening. Overall dimensions 1 1/8" dia. x 1/4" thick.
$1.75
Spring - Leslie, Tension, for Upper Belt
Replacement upper belt tension spring for Leslies.
$14.45
Aligner tool - GC Electronics, Duplex
Butyrate shaft 6-1/8" long with 1/8" wide steel tips. Tip on one end recessed.
  • Material: Conductive Nylon Metal
  • End: 1/8"
  • End 2: 1/8"
$1.99
Relay - SPDT, Leslie 122 Retrofit
Reliable replacement relay for the Leslie 122. The small size makes this high quality relay easy to retrofit in the 122. Its performance exceeds the original relays used in the Leslie 122 with its very low switching noise and high ratings on both the contacts and the coil.
Features:
  • 8 mm, 6 kV (1.2/50 µs) isolation, coil-contacts
  • Coil EMC suppression
  • Cadmium Free contact material
$29.95
On Backorder
Washer - Rubber, Chassis Mount, ⅞" Diameter
Gum rubber chassis mounting washers as used on thirties vintage Zenith and Philco radio. Allows proper dial centering in cabinet opening. Overall dimensions 0.875" dia. x .233" thick.
$0.75
Bearing - Leslie, Lower Rotor, sealed
Sealed lower rotor bearing for Leslies.
$11.50
Wire - 18 Gauge, 2 conductor, braided Power Cord
Brown 2 conductor 18 gauge, stranded power cord, similar to woven cloth covered cords in early AC radios. 105°C temperature rating, 600V.
Starting at $25.00
Grommet - Motor Mounting, package of 9
Package of 9
Rubber grommets for mounting phonograph motors. 1/2 dia. 5/16" high and ¼" inner dia.
$6.75
Socket - Leslie, 6 Pin Female, wavy washer
6 pin female socket with wavy washer, for Leslies.
$26.95
On Backorder
Power Supply - Power All System, For Effects Pedals
The Power-All PA-9 Digital Power Supply is the world’s first 2,000 mA, single outlet power supply designed specifically for guitar effect users. Don’t waste money on batteries or take up valuable space with multiple “wall wart” adaptors or power bricks – the Power-All system can power your entire pedalboard from a single power supply that takes up only one outlet! The Power-All provides 9 volts DC at 2,000 milliamps – more than enough current to power dozens of effect pedals, including up to four Line 6 Modelers! The Power-All’s special circuit design offers the lowest noise floor of any digital power supply on the market. The PA-9 now comes with a ferrite-core filter built onto its output cable to further reduce noise and hum.
Starting at $24.95
Power Supply - Power All System, 9V, 2000mA, for Effects Pedals
The PA-9 Power-All is the world's first 2000 mA, single outlet power supply designed specifically for guitar effect users. Don't waste money on batteries or take up valuable space with multiple "wall wart" adaptors or power bricks - the Power-All system can power your entire pedalboard from a single power supply that takes up only one outlet! The Power-All's special circuit design offers the lowest noise floor of any digital power supply on the market. The PA-9S now comes with a ferrite-core filter built onto its output cable to further reduce noise and hum.
$19.95
On Backorder
Vibrator - 4 Pin, for automobile radio
New manufacture solid-state replacement 4 pin vibrators. These replace our old line of solid state vibrators. 1-1/2 dia. x 2-¾" high aluminum can. Replace your buffer capacitor when you replace your vibrator!
Starting at $34.95
Grommet Kit - All Rubber Parts, for Leslie
Package of 33
Replace deteriorated rubber parts in Leslie cabinets. Includes grommets, o-rings, bushings, plug.
$61.25
Cable - Power All, 5 Lead Right Angle Daisy Chain
Right Angle Daisy Chain connector with standard polarity tip negative/barrel positive plugs connects the PA-9 Power-All to five effect pedals. The Cable-5/R can also be used with Power-All jumper cables to power effects that use different style jacks (reverse polarity, phone plug, battery clip, etc.). You can also link multiple Cable-5/R connectors to power over twenty 9-volt effect pedals or similar devices
$7.50
Power Supply - Dunlop, 9V, 200mA, Barrel, Center Negative

Dunlop ECB003 US wallwart power supply. Barrel connector.

  • Voltage: 9VDC
  • Current: 200mA
  • Tip Negative; Sleeve positive
$12.65
Cement - GC Electronics, Service Cement
A quick-drying, waterproof clear adhesive which forms a strong, hard, water and vibration-resistant bond with minimal shrinkage. Ideal for speaker repairs and bonding semi-porus materials to each other or to metals, plastics, etc. 2 oz. bottle. Can be used as a glue for small speaker cone repairs.
$9.95
On Backorder
Diode - 1N34A Germanium, low leakage
The 1N34A Germanium diode is an old standby in electronics. Widely used for detecting the rectifying efficiency or for switching on a radio, TV or stereo etc.
$1.75
Cable - Power All, Black Right Angle Extension Jumper
Included in the Power-All System and also sold separately, the Cable-Black/R allows the user to power over-sized effect units or units w/AC jacks in hard-to-reach places off of the Power-All Daisy Chain. The Cable-Black can be connected to any plug on any Power-All daisy chain, or directly to the PA-9 itself.
$3.00
Switch - for Run Circuit in Hammond Organ
Switch for run circuit in Hammond Organ. Electrical Rating: 16 A - 125 V 8 A - 250 V Dimensions: Mounting Diameter: ½" Bushing Length: 0.425" Length: 1.89" Width: 0.82" Depth: 0.69"
$29.95
Plastic Polish - Novus #1, plastic clean and shine
Cleans and glazes plastic surface polish out and protect against small scratches, finger markings, dust build-up, and other markings. Significantly reduces haziness and is anti-static.
Starting at $3.25
Wire - 20 AWG Stranded Core, Lacquered Cloth Cover, 600V
Colors Available:
#20 stranded copper wire with modern insulation and lacquered cotton braid finish. Provides safety and authentic vintage look. 105°C temperature rating, 600V. For a solid core version, see: S-W8XL
Starting at $4.00
Cable - Power All, Green Right Angle Line-6 Extension Jumper
Included in the Power-All system and also sold separately, the Cable-Green Right Angle jumper allows the user to power Line-6 Stomp-Box modelers and other digital effect units from the PA-9. The Cable-Green features a reverse-polarity (tip positive), right-angle male barrel connector with a larger, 2.5 mm internal diameter and spring-loaded clips.
$3.00