You are here

Semiconductors

Filter these results
Sort By:
products per page
View Mode: List View · Grid View
P-Q1N474XDiode - Zener, 1W, 1N4741A, 1N4748A

A semiconductor device that, above a certain reverse voltage(the zener value) has a sudden rise in current. If forward biased, the diode is an ordinary rectifier. When reverse biased, it exhibits a sharp break in its current-voltage graph. Voltage across the diode remains essentially constant for any further increase of reverse current.


$0.15
Click to read more
P-QPF5102Transistor - JFET N-Ch Transistor Lo Freq / Lo Noise, PF5102

PF5102 N-Channel Switch (TO-92 package) - designed for low level analog switching, sample and hold circuits and chopper stabilized amplifiers.



  • Max drain to gate voltage = 40 V
  • Max gate to source voltage = -40 V
  • Max forward gate current = 50 m

$0.75
On Backorder
Click to read more
P-QTL072Op-Amp - TL072, low-noise JFET dual operational amplifier

The TL072is a high speed JFET input dual operational amplifier incorporating well matched, high voltage JFET and bipolar transistors in a monolithic integrated circuit. The device features high slew rates, low input bias and offset current, and low offset voltage temperature coefficient.


$0.70
Click to read more
P-QBS170Transistor - Mosfet BS170, Small Signal
MOSFET BS170 N-Channel Transistor. Used in MOD® Kits.

Note - this is a fragile component! Use caution not to overheat or break leads.
$1.25
Click to read more
P-QSJE5331Transistor - Peavey, SJE 5331, 120V, 3A

SJE 5331, 120V, 3A, Case-77.


$1.50
Click to read more
P-QSJE5332Transistor - Peavey, SJE 5332, 120V, 3A

SJE 5332, 120V, 3A, Case-77.


$1.65
Click to read more
P-Q2N3055Transistor - 2N3055, High Power NPN Silicon, TO-3 Case
15 A, 60 V, 115 W
EPIBASE - Designed for power amplifier and switching regulator applications. The best choice where high frequency response, low switching losses and good safe operating area are required.
  • Current Gain - Bandwidth Product - fT = 2.5 MHz (Min) @ Ic = 1.0 Adc
  • Safe Operating Area - Full Power Rating to 40 V
$2.25
Click to read more
P-QMC78L05Regulator - 5 Volt, used in MOD® Pedal Kits

5V Linear Regulator. Used in MOD® kits. This fixed-voltage monolithic integrated circuit voltage regulator is suitable for applications that required supply current up to 100 mA.


$1.25
Click to read more
P-QHFA08Diode - Hexfred, ultrafast soft recovery, 8A, 600V

High performance, ultrafast diodes. Improve efficiency, reduce noise, allow higher frequency operation.


$2.75
Click to read more
P-QNE5532Integrated Circuit - NE5532, Low-Noise Dual Op-Amp
This a high performance dual low noise operational amplifier. Compared to the standard dual operational amplifiers, such as the NJM1458, it shows better noise performance, improved output drive capability, and considerably higher small-signal and power bandwidths. it is compensated internally for voltage follower circuit. This makes the device especially suitable for application in high quality and professional audio equipment, instrumentation, control circuits, and telephone channel amplifiers
Features:
  • Operating Voltage = ±3V~±22V
  • Small Signal Bandwidth = 10MHz typ.
  • Output Drive Capability = 600Ω,10Vrms typ.
  • Input Noise Voltage = 5nV/√Hz typ.
  • Power Bandwidth = 140kHz typ.
  • Slew Rate = 8V/µs typ.
  • Bipolar Technology
$1.15
Click to read more
Don't see a product you're looking for? Send us your product suggestions!
Subscribe to RSS - Semiconductors