You are here


Filter these results
Sort By:
products per page
View Mode: List View · Grid View
P-QPC1188HIntegrated Circuit - Fender®, Power Amp PC1188H
PC 1188H Power Amp - Fender
The PC1188H is a monolithic integrated circuit and a power amplifier designed for Hi-Fi audio sets. The PC1188H can provide 20W (typical) to 8 ohms at 1% T.H.D. and +/- 22V supply voltage.
  • High output power
  • Low distortion
  • Wide frequency bandwidth
  • A muting function which eliminates pop on noise and the thermal and the over current protection circuit
Click to read more about this product.
P-QTL604-AKKit - Peavey, TL604 Adapter
Peavey’s TL604 Adapter Kit.
You will need soldering iron, solder and a bit of installation ingenuity (parts and instructions included).
The TL604 dual analog switch is obsolete and no longer available. Please note that this adapter kit will effectively replace the 604 and provide the same functions required in Peavey products. The only drawback, of course, is the size of the board versus the original part.
Click to read more about this product.
P-QMJ15025Transistor - MJ15025, TO-3 Case
Transistor MJ15025, TO-3 Case
The MJ15025 is a power transistor designed for high-power audio, disk head positioners, and other linear applications
  • High Safe Operating Area: -2A @ 80 V
  • High DC Current Gain hFE = 15 (Min) @ IC = 8 Adc
Click to read more about this product.
P-QMJE15029Transistor - Kustom, MJE15029 PNP Bipolar Power

MJE15029 PNP bipolar power transistor (TO-220 package). Designed for use as high-frequency drivers in audio amplifiers.

  • Max collector to emitter voltage = 120 V
  • Max collector to base voltage = 120 V
  • Max emitter to base voltage = 5 V
  • Max collector current (continuous) = 8 A

Click to read more about this product.
P-QA18937Transistor - Fender®, A18937

A18937 Transistor - Fender

Click to read more about this product.
P-QDG212CJIntegrated Circuit - Korg, For Marshall, DG212CJ

Korg IC DG212CJ Used in certain Marshall amplifiers

Click to read more about this product.
P-QSBS14Diode Thyristor - Peavey, SBS 14 Bidirectional, 8V, TO-92 Case

Designed for full-wave triggering in Triac phase control circuits, half-wave SCR triggering application and as voltage level detectors. Used in most Peavey linear power amplifier designs through 2000 including CS/M/DECA series power amps, IPA300, and all models using 402/602/304S/204S power modules.

  • Low Switching Voltage — 8 Volts Typical
  • Uniform Characteristics in Each Direction
  • Low On-State Voltage — 1.7 Volts Maximum
  • Low Off-State Current — 0.1 mA Maximum

Click to read more about this product.
P-Q1N4006Diode - 1A 800V
A semiconductor device which passes current in the forward direction(from anode to cathode), and blocks current in the opposite direction.
Click to read more about this product.
P-QHFA16PDiode - Hexfred, 16A, 1200V
High performance, ultrafast diodes. Improve efficiency, reduce noise, allow higher frequency operation.
Click to read more about this product.
P-QLM34015Transistor - Kustom, LM340-15, Fixed-Voltage Regulator
LM340-15, regulator.
This family of fixed voltage regulators are monolithic integrated circuits capable of driving loads in excess of 1.0 A. These three–terminal regulators employ internal current limiting, thermal shutdown, and safe–area compensation.
Although designed primarily as a fixed voltage regulator, these devices can be used with external components to obtain adjustable voltages and currents. This series of devices can be used with a series–pass transistor to boost output current capability at the nominal output voltage.
  • Output Voltage 15V
  • Output Current in Excess of 1.0 A
  • No External Components Required
  • Internal Thermal Overload Protection
  • Internal Short Circuit Current Limiting
  • Output Transistor Safe–Area Compensation
Click to read more about this product.
Subscribe to RSS - Semiconductors