You are here

Semiconductors

Filter these results
Sort By:
products per page
View Mode: List View · Grid View

Pages

(6 pages)
P-QLM386N1Audio Power Amplifier - LM386N-1, Low Voltage

LM386 Low Voltage Audio Power Amplifier The LM386 is a mono low voltage amplifier that can be used in a variety of applications. It can drive loads from 4 Ω to 32 Ω. The gain is internally set to 20 but it can be modified from 20 to 200 by placing a resistor and capacitor between pins 1 and 8. As this is an Op Amp it can be used in different configurations to fit in several applications. The internal gain setting resistor allows the LM386 to be used in a very low part count system. In addition a series resistor can be placed between pins 1 and 5 to modify the gain and frequency response for specific applications. These are found in many small audio amplifiers and even tiny pedal sized guitar amplifiers! There are tons of possibilities for this little Op Amp.


$1.25
Click to read more
P-QOPAMPDDOp-Amp - Orange, Dual Discrete, Low-Noise, 8-Pin DIP

The Dual Discrete op-amp is specially designed for audio and is among the most musical sounding dual discrete op-amps out there. It is available in DIP 8 format and can be used in any CD player, DAC, or preamplifier that currently runs DIP 8 based IC dual op-amp types. The overall soundstage and transient detail will be greatly improved when used in pretty much all audio equipment that it can physically be fitted to. It has a very low noise Jfet front end so it can run with input impedances above 1M Ohms if needed. It can replace the following, provided the equipment it’s being used in has 22mm of height clearance and 5mm side clearance (per side).



  • OPA2604
  • OPA2134
  • TL072
  • NE5532
  • LM4562
  • OP275
  • OP285


Please check that the PSU can supply the extra current needed, especially if replacing more than one existing IC op-amp with our op-amp as with all discrete types, they do draw more current.


$55.00
Click to read more
R-VTL5C1-POptocoupler - Vactec, VTL5C1, Vactrol, New Old Stock

New old stock Vactec VTL5C1 vactrols from Perkin Elmer Optoelectronics. These premium vactrols are a great choice for use in phasers, compressors, tremolos, and synth modules such as low-pass gates. They are also used in switching circuits in amplifiers. Limited quantities are available.

$10.95
Click to read more
P-QPT2399Integrated Circuit - PT2399, Echo / Delay

PT2399 echo/delay chip used in many DIY and commercial pedals. The PT2399 is in a DIP 16 package. Minimal external components are required for use and delay time is set with resistance.


$0.78
Click to read more
P-QTL062Op-Amp - TL062, Dual, Low-Power, JFET Input, 8-Pin DIP

Dual low power opamps in an 8-pin DIP package. The TL062 offers a high input impedance and 1MHz bandwidth.


$0.28
Click to read more
P-QTL082Op-Amp - TL082, Dual, Wide-Bandwidth, JFET Input, 8-Pin DIP

Dual wide-bandwidth TL082 opamps in an 8-pin DIP package. The TL082 offers a high input impedance and 4MHz bandwidth.


$0.21
Click to read more
P-QLF353Op-Amp - LF353, Dual, Wide-Bandwidth, JFET Input, 8-Pin DIP

Dual wide-bandwidth LF353 opamps in an 8-pin DIP package. The LF353 offers a high input impedance and 3MHz bandwidth.



This LF353 device is a low-cost, high-speed, JFET input operational amplifier with very low input offset voltage. It requires low supply current yet maintains a large gain-bandwidth product and a fast slew rate. In addition, the matched high-voltage JFET input provides very low input bias and offset currents.


$0.34
Click to read more
P-QLM324Op-Amp - LM324, Quad, Low-Power, 14-Pin DIP

Quad low-power opamps in an 14-pin DIP package. The LM324 offers a 1MHz bandwidth and can be powered from a single supply.


$0.18
Click to read more

Pages

(6 pages)
Don't see a product you're looking for? Send us your product suggestions!
Subscribe to RSS - Semiconductors