You are here

Semiconductors

Filter these results
Sort By:
products per page
View Mode: List View · Grid View

Pages

(6 pages)
P-QLM386N1
P-QLM386N1
Item ID: 040466
Audio Power Amplifier - LM386N-1, Low Voltage

LM386 Low Voltage Audio Power Amplifier The LM386 is a mono low voltage amplifier that can be used in a variety of applications. It can drive loads from 4 Ω to 32 Ω. The gain is internally set to 20 but it can be modified from 20 to 200 by placing a resistor and capacitor between pins 1 and 8. As this is an Op Amp it can be used in different configurations to fit in several applications. The internal gain setting resistor allows the LM386 to be used in a very low part count system. In addition a series resistor can be placed between pins 1 and 5 to modify the gain and frequency response for specific applications. These are found in many small audio amplifiers and even tiny pedal sized guitar amplifiers! There are tons of possibilities for this little Op Amp.


$1.25
Click to read more
R-VOP1020
R-VOP1020
Item ID: 003858
Switch - Vibrato LDR, for Fender® Amps
Optocoupler. Vibrato LDR for Fender Amps.
Fix the dead LDR style tremolo on your vintage Fender amps as well as others.
  • Non- polarized optical side is indicated by silver dot and slightly longer leads
  • Resistive side is indicated only by slightly shorter leads

This information can also be found within the diagram located in the Specifications, Files, and Documents section on this page.
$8.95
Click to read more
R-VTL5C1
R-VTL5C1
Item ID: 003933
Optocoupler - VTL5C1, Vactrol, for Channel Switching

VTL5C1 vactrols for use in amplifiers, effect pedals, synthesizers and more. The VTL5C1 was commonly used for channel switching circuits in amps made by Crate and others.


$7.95
Click to read more
P-QNE5532
P-QNE5532
Item ID: 003239
Op-Amp - NE5532, Dual, Low-Noise, 8-Pin DIP

This a high performance dual low noise operational amplifier. Compared to the standard dual operational amplifiers, such as the NJM1458, it shows better noise performance, improved output drive capability, and considerably higher small-signal and power bandwidths. it is compensated internally for voltage follower circuit. This makes the device especially suitable for application in high quality and professional audio equipment, instrumentation, control circuits, and telephone channel amplifiers Features:



  • Operating Voltage = ±3V~±22V
  • Small Signal Bandwidth = 10MHz typ.
  • Output Drive Capability = 600Ω,10Vrms typ.
  • Input Noise Voltage = 5nV/√Hz typ.
  • Power Bandwidth = 140kHz typ.
  • Slew Rate = 8V/µs typ.
  • Bipolar Technology

$1.15
Click to read more
P-QBR-34
P-QBR-34
Item ID: 003217
Rectifier - Single-phase Bridge, 3A 400V

A full wave rectifier with 4 elements in a bridge circuit so that DC voltage is obtained from one pair of junctions when an AC voltage is applied to another pair of junctions.


$0.95
Click to read more
P-QBS170
P-QBS170
Item ID: 003218
Transistor - Mosfet BS170, Small Signal
MOSFET BS170 N-Channel Transistor. Used in MOD® Kits.

Note - this is a fragile component! Use caution not to overheat or break leads.
$1.25
Click to read more
P-QTL072
P-QTL072
Item ID: 003261
Op-Amp - TL072, Dual, Low-Noise, JFET Input, 8-Pin DIP

The TL072is a high speed JFET input dual operational amplifier incorporating well matched, high voltage JFET and bipolar transistors in a monolithic integrated circuit. The device features high slew rates, low input bias and offset current, and low offset voltage temperature coefficient.


$0.70
Click to read more
P-QTL074
P-QTL074
Item ID: 003262
Op-Amp - TL074, Quad, Low-Noise, JFET Input, 14-Pin DIP

Low noise JFET quad operational amplifier. Incorporates well matched, high-voltage JFET and bipolar transistors in a monolithic integrated circuit. Features high slew rates, low input bias and offset currents, and low offset voltage temperature coefficients. Features:



  • Wide common-mode and differential voltage range
  • Low input bias and offset current
  • Low noise en = 15 nV/HZ
  • Output short-circuit protection
  • High input impedance JFET input stage
  • Low harmonic distortion: 0.01%
  • Internal frequency compensation
  • Latch up free operation
  • High slew rate: 16 V/us (typical)

$1.15
Click to read more
P-Q1N5408
P-Q1N5408
Item ID: 003206
Diode - standard recovery rectifier, 3A, 1000V, 1N5408

1N5408 Diode. Lead mounted standard recovery rectifiers are designed for use in power supplies and other applications having need of a device with the following features:



  • High Current to Small Size
  • High Surge Current Capability
  • Low Forward Voltage Drop

$0.38
Click to read more
P-QMJ15016
P-QMJ15016
Item ID: 003229
Transistor - MJ15016, PNP, Complementary High-Power
Transistor MJ15016, TO-3 Case, PNP

PowerBase complementary transistors designed for high power audio, stepping motor and other linear applications. These devices can also be used in power switching circuits such as relay or solenoid drivers, dc–to–dc converters, inverters, or for inductive loads requiring higher safe operating areas.

Safe Operating Area - Rated to 60V
$2.85
Click to read more

Pages

(6 pages)
Don't see a product you're looking for? Send us your product suggestions!
Subscribe to RSS - Semiconductors