Terminal Boards & Strips

Turret staking tool for use with our turrets (S-HTUR-SG-2X, S-HTUR-SG-3X, S-HTUR-PR-3S).
For anvil see S-T1717
For smaller staking tool, see S-T1714
Directions:

• Drill 1/8" hole
• Insert eyelet
• Flip board over on to a hard service
• Center staking tool over the eyelet
• Strike staking tool with hammer to clamp eyelet to board

Staking tool for small eyelets such as S-HEYE-B. Directions:

• Drill hole using #42 drill bit
• Insert eyelet
• Flip board over onto a hard service
• Center staking tool over the eyelet
• Strike staking tool with hammer to clamp eyelet to board

230 x 70 mm, loaded with 33 turrets,2 mm board thickness. This is designed for a 5E3 board.

258 x 76 mm, loaded with 52 turrets, 3 mm board thickness. This is designed for a for a JTM45 board. Our turrets, part number S-HTUR-BX will fit on this board.

Single socket, 2 rows/6 lugs per row, 4 mounting holes. Board dimensions 3" x 3". Terminals are not pre-wired.

Turret board with pre installed turrets designed to be used to build a 5F6A layout or variants. Includes the required 2 pieces

• 2mm board
• 5F6A Layout
• Includes 2 pieces

Dual socket. 2 rows/12 lugs per row, 4 mounting holes. Board dimensions 5 ¼" x 3". Terminals are not pre-wired.

Original Crybaby replacement circuit board for pedals made after 1990. Original Dunlop replacement part.

Genuine Fender® Mid Boost upgrade kit for Strats with active electronics. This circuit is used in the signature Eric Clapton and Buddy Guy strats and is commonly referred to as the Clapton Boost. The Mid Boost knob adjusts gain from 0 dB (no boost) to 25 dB (maximum boosted mids). This boost sounds great clean and adds powerful control to distortion.

Replacement board for Marshall JCM 2000 DSL 100 amplifiers which frequently have issues with original boards. This replacement can bring your amp back to life!

Marshall PC Board for TSL 100 / 122. Rev 20.