Transformer - Output, 8 W, 4kΩ - 9kΩ impedance
Specifications | |
---|---|
Output | 8 W |
Primary Impedance | 4,000 to 9,000 Ω |
Mounting Centers | 2.375" |
Weight | 0.7 lbs |
Specification:
Wiring Diagram:
Item Height | 1.643 in. | ||
Item Length | 2.797 in. | ||
Item Width | 1.445 in. | ||
Mounting Hole Center to Center A | 2.4 in. | ||
Mounting Hole Diameter | 0.18 in. | ||
Output | 8 W | ||
Primary Impedance | 4k Ω - 9 kΩ |
Packaging Dimensions | 2.8 in. × 1.8 in. × 1.8 in. | ||
Weight (Packaging) | 0.6283 lbs. |
Wiring Diagram | All Models |
Specification | All Models |
My Project Lists
Questions? Contact us at [email protected], or give us a call at 480-820-5411
Product Reviews
I bought the Philco as is at an antique radio show, disassembled it and refinished the cabinet. Then I replaced all the capacitors (from AES)and diagnosed an open primary circuit on the output transformer, a common problem on this model. I found a recommendation on the internet for this AES transformer and the electrical specs were close to the original, as far as I could tell from the limited info on the schematic. One blog reported hum and other issues from an impedance mismatch so I was a little skeptical. But it bolted right up to the same holes in the chassis and I wired to C, 1, and 2 on the secondary side and it works PERFECTLY!!! No hum or buz and the radio works every bit as good as I expected (for a 1941 model). I'm no electronics expert, self taught, so needless to say I was ecstatic to hear it play for the first time, maybe in decades. I'm so glad AES has resto products for a guy like me that likes to bring the dead back to life, so to speak. Thanks AES!
I used this product in a 6V6 push pull circuit and it worked great. Has great sound. The multiple taps are a good feature.
I used the transformer in a Crosley Super 6 Table Radio. The Radio has a push pull audio and the transformer made a perfect replacement. Sounds Great.
A great output transformer. When I replace the old general purpose AES output transformer with this one on my 4 tube DC superheat receiver, the out put volume on the speaker instantly improved. It is a push- pull output transformer but I am using only 2 leads ( red lead omitted) as my audio section is single ended. It is matching great with my 4 ohms speaker. I am using taps C and 1 that gives an output impedance of 9000 ohms.
I will recommend this product strongly.
this transformer was easy to install, and worked very well thanks robin