You are here

Transformers & Chokes

Filter these results
Sort By:
products per page
View Mode: List View · Grid View

Pages

(19 pages)
Transformer - Hammond, Plate & Filament
  • Universal primary with taps for 100, 120, 220 or 240 VAC, 50 / 60 Hz. (Except the 260A6 which is 117V, 50/60 Hz only)
  • Designed for preamps, low power amps, general replacement, test equipment, etc.
  • Economical, open frame, chassis mount - two hole (.187 dia. = G) channel bracket (figure #1) or four hole mounting (figure #2).
  • Units include a Faraday shield between the primary and secondary windings. Our electrostatic shield reduces the capacitive coupling from the primary - greatly attenuating higher frequency current coupling to the secondaries.
  • Minimum 5" long leads.
  • For more selection check out our P-T300-X series of universal plate & filament transformers.

Starting at $74.84
Click to read more
P-T166-36Transformer - Hammond, Low Voltage / Filament, Open, 36 VCT
  • Open style, chassis mount transformers with a 115V 60Hz or 117V 50/60Hz primary and a 36V center tapped secondary.

Starting at $15.03
Note:
P-T166E36: 5.4
P-T166F36A: 10.8 - 117V primary
are special order items.
Note: some of these items are special order items.
Click to read more
P-T144-XTransformer - Hammond, 144 Series, Audio Chassis Mount

Special Order Item

Features:



  • Small, economical, open, two hole horizontal bracket mount.
  • Insulated, color coded flexible leads, 4" long minimum
  • Frequency response 150 Hz. to 15 Khz. (+/- 1 db, reference 1000 Hz.)
  • When operating at impedances below nominal, power capability and the frequency spectrum are proportionately lower, conversely, at higher impedances power capability and frequency spectrum will be proportionately higher.

$18.14
Note: special order items require additional lead time. See our page on special order items.
Note: this is a special order item.
Click to read more
P-C1536XChoke - 0.17 - 250, Heavy Duty Hash Choke
Molded powdered iron core.
1-1/4 long axial leads.
High inductance & high current.
L measured at 1 Khz. Inductance: 250 µH20% tolerance
DC resistance ohms: .17
Self Resonant Frequency (MHz): 1.5
Maximum DC current amps: 2.5
Coil diameter (in): .43
Core Length (in): 1.25
$1.08
Click to read more
P-TM950OTransformer - Marshall, Output, 50 W, for JCM 900

Genuine Marshall™ output transformer for JCM900 and JCM2000.


$117.80
Click to read more
P-TUBT-1Transformer - One Electron, Output, 1600 Ω to 16/8/4 Ω

The UBT-1 from One Electron is a low-impedance single-ended output transformer intended for parallel combinations of tubes running a B+ voltages of 250 to 325 volts, such as: two or three EL34s (triode connected), three 2A3s, two 300Bs, two 6AS7s, etc., as well as single sweep tubes run in 'enhanced-triode' mode, resulting in 10 to 15 watts of output power.


$125.00
Click to read more
P-TF37610Transformer - Fender®, Power, for '65 Twin Reverb Reissue

Made precisely to the original Fender® specifications. Drop-in replacement for '65 Twin Reverb Reissue. Made in the USA. 120V Primary.


$79.95
On Backorder
Click to read more
P-TM45PTransformer - Marshall Replacement, Power for JTM45

Replacement power transformer for Marshall JTM45.


$110.00
Click to read more
P-T290-YORKVILLETransformer - Hammond, Guitar Amplifier, replacement for Yorkville / Traynor
  • Replacement for Yorkville/Traynor amplifiers
  • Designed for drop in replacement of original units.
  • Physically, parts were designed to look similar to original factory units (where possible).
  • Material used & design specs. were kept as close as possible to the original part to preserve the stock "tone".


Part No. Primary Secondary 1 Secondary 2 Secondary 3 Yorkville / Traynor Amp Yorkville / Traynor Part No VAC Hz. P-T290TRA 120 V 60 Hz. 320 V @ 600 mA 60 V @ 50 mA 6.3 V.C.T. @ 9 A 100 Watt Bass A-1380 P-T290TRB 120 V 60 Hz. 620 V @ 115 mA 6.3 V.C.T. @ 115 mA YBA2-B A-1314 P-T291JX 120 V 60 Hz. 320 V @ 500 mA 60 V @ 20 mA 6.65 V.C.T.


Starting at $76.50
Click to read more
P-T145-XTransformer - Hammond, 145 Series, Audio Chassis Mount

Features:



  • Small, economical, open, two hole horizontal bracket mount.
  • Insulated, color coded flexible leads, 4" long minimum
  • Frequency response 150 Hz. to 15 Khz. (+/- 1 db, reference 1000 Hz.)
  • When operating at impedances below nominal, power capability and the frequency spectrum are proportionately lower, conversely, at higher impedances power capability and frequency spectrum will be proportionately higher.

$18.14
Note:
P-T145D: 200kΩ / 1kΩ
P-T145A: 100Ω / 200Ω
P-T145O: 15kΩ / 200Ω
P-T145P: 20kΩ / 1kΩ
P-T145R: 20kΩ / 2kΩ
P-T145G: 2kΩ / 200Ω
P-T145H: 2kΩ / 500Ω
P-T145L: 4kΩ / 2.6kΩ
P-T145C: 50kΩ / 1.5kΩ
P-T145F: 600Ω / 200Ω
P-T145E: 600Ω / 600Ω ct
are special order items.
Note: some of these items are special order items.
Click to read more

Pages

(19 pages)
Don't see a product you're looking for? Send us your product suggestions!
Subscribe to RSS - Transformers & Chokes