You are here

Transformers & Chokes

Filter these results
Sort By:
products per page
View Mode: List View · Grid View

Pages

(19 pages)
P-T145-XTransformer - Hammond, 145 Series, Audio Chassis Mount

Features:



  • Small, economical, open, two hole horizontal bracket mount.
  • Insulated, color coded flexible leads, 4" long minimum
  • Frequency response 150 Hz. to 15 Khz. (+/- 1 db, reference 1000 Hz.)
  • When operating at impedances below nominal, power capability and the frequency spectrum are proportionately lower, conversely, at higher impedances power capability and frequency spectrum will be proportionately higher.

$18.14
Note:
P-T145D: 200kΩ / 1kΩ
P-T145A: 100Ω / 200Ω
P-T145O: 15kΩ / 200Ω
P-T145P: 20kΩ / 1kΩ
P-T145R: 20kΩ / 2kΩ
P-T145G: 2kΩ / 200Ω
P-T145H: 2kΩ / 500Ω
P-T145L: 4kΩ / 2.6kΩ
P-T145C: 50kΩ / 1.5kΩ
P-T145F: 600Ω / 200Ω
P-T145E: 600Ω / 600Ω ct
are special order items.
Note: some of these items are special order items.
Click to read more
P-C1536XChoke - 0.17 - 250, Heavy Duty Hash Choke
Molded powdered iron core.
1-1/4 long axial leads.
High inductance & high current.
L measured at 1 Khz. Inductance: 250 µH20% tolerance
DC resistance ohms: .17
Self Resonant Frequency (MHz): 1.5
Maximum DC current amps: 2.5
Coil diameter (in): .43
Core Length (in): 1.25
$1.08
Click to read more
P-T171XTransformer - Hammond, Isolation / plug & receptacle
  • Primary 115VAC, 50 / 60 Hz., Secondary 115VAC
  • Provides complete circuit isolation.
  • Electrostatic shield between primary & secondary to greatly attenuate surges and noise.
  • Hi-pot tested to 2 KV RMS.
  • Circuit breaker in primary.
  • Standard 3-wire, grounded plug & receptacle.
  • Input (primary) connected to 5 foot long cord & standard North American plug (NEMA 5-15P).
  • Output (secondary) connected to 1 foot long "pig tail" cord, 3-wire, standard North American grounded receptacle (NEMA 5-15R).
  • North American Mark of Safety - C UL & UL listed (File #E211544)
  • Indoor use only
  • Remember - These units do NOT convert line frequency

Starting at $87.42
Click to read more
P-T166-36Transformer - Hammond, Low Voltage / Filament, Open, 36 VCT
  • Open style, chassis mount transformers with a 115V 60Hz or 117V 50/60Hz primary and a 36V center tapped secondary.

Starting at $15.03
Note:
P-T166E36: 5.4
P-T166F36A: 10.8 - 117V primary
are special order items.
Note: some of these items are special order items.
Click to read more
P-T144-XTransformer - Hammond, 144 Series, Audio Chassis Mount

Special Order Item

Features:



  • Small, economical, open, two hole horizontal bracket mount.
  • Insulated, color coded flexible leads, 4" long minimum
  • Frequency response 150 Hz. to 15 Khz. (+/- 1 db, reference 1000 Hz.)
  • When operating at impedances below nominal, power capability and the frequency spectrum are proportionately lower, conversely, at higher impedances power capability and frequency spectrum will be proportionately higher.

$18.14
Note: special order items require additional lead time. See our page on special order items.
Note: this is a special order item.
Click to read more
P-TM950OTransformer - Marshall, Output, 50 W, for JCM 900

Genuine Marshall™ output transformer for JCM900 and JCM2000.


$117.80
Click to read more
P-TUBT-1Transformer - One Electron, Output, 1600 Ω to 16/8/4 Ω

The UBT-1 from One Electron is a low-impedance single-ended output transformer intended for parallel combinations of tubes running a B+ voltages of 250 to 325 volts, such as: two or three EL34s (triode connected), three 2A3s, two 300Bs, two 6AS7s, etc., as well as single sweep tubes run in 'enhanced-triode' mode, resulting in 10 to 15 watts of output power.


$125.00
Click to read more
P-T-LEHLE-HZ-LTransformer - Lehle, Audio, Line Isolation, High Impedance

The Lehle Transformer HZ is the ideal component to avoid hum loops or to balance and unbalance signals without degrading the sound of high impedance signal sources.


$68.75
Click to read more
P-T125JTransformer - Hammond, Output, 8 W, 2.5k or 4k Primary

Specifications Audio Watts: 8 Primary Impendance (Ohms): 2.5k/4K center-tapped Secondary Impendance (Ohms): 6/8 - 3.2/4 Mounting centers: 2-13/16u-bracket Weight: 1.0 lb.


$36.99
Click to read more
P-T143Transformer - Hammond, Power, 350-0-350V, 70-90 mA

Custom manufactured to replace most 6 and 7 tube sets of the early 1930s. Supplied with vertical mounting shells. Provides a seperate filament winding for audio output stages. Specifications Rating: 350-0-350 V, 70 or 90 mA (if 5 V winding is used with 2 A rectifier) Windings: 5 V, 3 A; 2.5 V, 7.5 A; 2.5 VCT, 3.5 A Mounting Centers:2 x 2.625" Weight: 4.2 lbs. Overall Height: 3.12"


$105.95
On Backorder
Click to read more

Pages

(19 pages)
Don't see a product you're looking for? Send us your product suggestions!
Subscribe to RSS - Transformers & Chokes