You are here

Transformers & Chokes

Filter these results
Sort By:
products per page
View Mode: List View · Grid View

Pages

(15 pages)
P-T171XTransformer - Hammond, line isolation / plug & receptacle

Special Order Item

  • Primary 115VAC, 50 / 60 Hz., Secondary 115VAC
  • Provides complete circuit isolation.
  • Electrostatic shield between primary & secondary to greatly attenuate surges and noise.
  • Hi-pot tested to 2 KV RMS.
  • Circuit breaker in primary.
  • Standard 3-wire, grounded plug & receptacle.
  • Input (primary) connected to 5 foot long cord & standard North American plug (NEMA 5-15P).
  • Output (secondary) connected to 1 foot long "pig tail" cord, 3-wire, standard North American grounded receptacle (NEMA 5-15R).
  • North American Mark of Safety - C UL & UL listed (File #E211544)
  • Indoor use only
  • Remember - These units do NOT convert line frequency

$105.96
Starting at $83.26
You save: 21%
Note: special order items require additional lead time. See our page on special order items.
Note: this is a special order item.
Click to read more
P-RC-3Choke - One Electron, Audio, PRC-3, 225H for Preamp Output

The PRC-3 audio choke from One Electron was designed as a plate load for the output of either a high quality line amplifier or a phono preamp.


$69.95
Click to read more
P-TF37610Transformer - Fender®, Power, for '65 Twin Reverb Reissue

Made precisely to the original Fender® specifications. Drop-in replacement for '65 Twin Reverb Reissue. Made in the USA. 120V Primary.


$79.95
Click to read more
P-TF413160Transformer - Fender, Power, for Deluxe Reverb 120V
Genuine Fender power transformer designed for use in the ‘65 Deluxe Reverb as well as the ‘68 Deluxe. Made to original fender specifications. 120V Primary
$74.95
Click to read more
P-T290-MARSHALLTransformer - Hammond, Guitar Amplifier, replacement for Marshall
  • Replacements for Marshall amps
  • Designed for drop in replacement of original units.
  • Physically, parts were designed to look similar to original factory units (where possible).
  • Material used & design specs. were kept as close as possible to the original part to preserve the stock "tone".

Starting at $96.50
Click to read more
P-TM45PTransformer - Marshall Replacement, Power for JTM45

Replacement power transformer for Marshall JTM45.


$110.00
Click to read more
P-TN-68XTransformer - Line Isolation, 50 VA, 115V, 435 mA, 2 x 115V

An Isolation Power Transformer for isolating equipment from direct connection to the power line. The transformer is constructed with non-concentrically wound coils. The primary and secondary are wound on separate arbors, then assembled on a laminate core side-by-side separated by insulation. This prevents electrical connection, under normal or overload conditions, between the primary and secondary windings.


$15.95
Click to read more
P-T164X-28Power Transformer - Hammond, 115V, 28VCT

Special Order Item

  • Both series operate on 50/60 Hz current
  • Low profile, split bobbin design.
  • Dual winding secondaries, non-concentrically wound
  • Units are designed so that all windings must be used
  • Low primary to secondary coupling - no electrostatic shield required.
  • High insulation - Hipot of 2,500V RMS.
  • Class B insulation - 130 degrees C.
  • c UL us recognized

Starting at $9.61
Note: special order items require additional lead time. See our page on special order items.
Note: this is a special order item.
Click to read more
P-T167G120Transformer - Hammond, Low Voltage / Filament, Enclosed, 120 VCT

Special Order Item

  • Primary 115 VAC, 60 Hz.
  • Secondary 120 C.T.
  • All secondaries center tapped, VAC (RMS)
  • Enclosed, 4 hole chassis mount.
  • Minimum 6" long leads.
  • Dual bobbin design - no electrostatic shield required.
  • Class B insulation (130 degrees C).
  • Hi-Pot test of 2,000V RMS.
  • UL listed (# E50394) & CSA certified (209651).

$41.43
Note: special order items require additional lead time. See our page on special order items.
Note: this is a special order item.
Click to read more
P-T125JTransformer - Hammond, Output, 8 W, 2.5k or 4k Primary

Special Order Item

Specifications Audio Watts: 8 Primary Impendance (Ohms): 2.5k/4K center-tapped Secondary Impendance (Ohms): 6/8 - 3.2/4 Mounting centers: 2-13/16u-bracket Weight: 1.0 lb.


$35.23
Note: special order items require additional lead time. See our page on special order items.
Note: this is a special order item.
Click to read more

Pages

(15 pages)
Don't see a product you're looking for? Send us your product suggestions!
Subscribe to RSS - Transformers & Chokes