You are here

Transformers & Chokes

Filter these results
Sort By:
products per page
View Mode: List View · Grid View

Pages

(19 pages)
Transformer - Hammond, Line Step Up Isolation, Toroidal, 500 VA
Capacity: 500 VA
Dimensions: 9" long by 6" wide by 4" height
Features:
  • Primary 120VAC, 50/60 Hz., Secondary 240VAC.
  • Provides circuit isolation.
  • Toroidal transformer for high isolation, low noise, light weight cool operation and low profile.
  • 50 or 60 Hz.
$270.24
Click to read more
P-T1182-40Transformer - Hammond, Toroidal Power, 40V / 80V secondary

Dual 117/234 VAC primary, 50/60 Hz. operation. 80 V series, 40 V parallel secondary.


$225.18
Click to read more
P-TBFT-1BTransformer - One Electron, BFT-1B, Power

The BFT-1B from One Electron was designed to power a stereo amplifier using UBT-1's in each channel but will also power an 80 watt push-pull tube amplifier. The BFT-1B is slightly larger than earlier versions of the BFT-1, allowing lower flux density and cooler operation. The tapped high-voltage windings and three filament windings provide flexibility in design. An electrostatic shield between the primaries and secondaries reduces power-line noise coupling. The primary arrangements allows use on virtually any power grid in the world.


$225.00
Click to read more
P-TF26477Transformer - Fender®, Power, for Tone Master

Fender® Original Tone Master Power Transformer. Equivalent to #026477.


$179.95
On Backorder
Click to read more
P-T162XSEATransformer - Hammond, Output, Single-Ended, 30 W
  • Over designed for single ended tube output circuits (triode, tetrode or pentode tubes).
  • Enclosed (shielded), 4 slot, above chassis Type 'X' mounting.
  • Frequency response at least 20 Hz. to 20 Khz. at full rated power (± 1 db max. ref.

$159.23
Click to read more
P-TM9100OTransformer - Marshall, Output, 100 W, for JCM900

Genuine Marshall™ 100 watt output transformer for JCM900 and JCM2000.


$139.95
Click to read more
P-TM45OTransformer - Marshall, Output, for JTM45

Genuine Marshall™ output transformer for JTM45.


$135.00
Click to read more
Transformer - Hammond, Step-Up, 500VA

Capacity: 500VA Features:



  • Single winding does not provide isolation, for use where equipment is already isolated and only voltage change is required.
  • World wide applications, 50 or 60 Hz.

$132.86
Click to read more
P-TUBT-2Transformer - One Electron, Output, 4800 Ω to 16/8/4 Ω

The UBT-2 from One Electron is the same size and power (15 watts) as the UBT-1, but has a higher primary impedance suitable for single tubes running at B+ voltages of 400 to 500 volts, such as: 50, WE 300B,etc.


$129.95
Click to read more
P-TUBT-1Transformer - One Electron, Output, 1600 Ω to 16/8/4 Ω

The UBT-1 from One Electron is a low-impedance single-ended output transformer intended for parallel combinations of tubes running a B+ voltages of 250 to 325 volts, such as: two or three EL34s (triode connected), three 2A3s, two 300Bs, two 6AS7s, etc., as well as single sweep tubes run in 'enhanced-triode' mode, resulting in 10 to 15 watts of output power.


$125.00
Click to read more

Pages

(19 pages)
Don't see a product you're looking for? Send us your product suggestions!
Subscribe to RSS - Transformers & Chokes