You are here

Transformers & Chokes

Filter these results
Sort By:
products per page
View Mode: List View · Grid View

Pages

(15 pages)
P-T298DTTransformer - Hammond, Line Step Up Isolation, Toroidal, 500 VA

Special Order Item

Capacity: 500 VA
Dimensions: 9" long by 6" wide by 4" height
Features:
  • Primary 120VAC, 50/60 Hz., Secondary 240VAC.
  • Provides circuit isolation.
  • Toroidal transformer for high isolation, low noise, light weight cool operation and low profile.
  • 50 or 60 Hz.
$327.56
Note: special order items require additional lead time. See our page on special order items.
Note: this is a special order item.
Click to read more
P-TBFT-1BTransformer - One Electron, BFT-1B, Power

The BFT-1B from One Electron was designed to power a stereo amplifier using UBT-1's in each channel but will also power an 80 watt push-pull tube amplifier. The BFT-1B is slightly larger than earlier versions of the BFT-1, allowing lower flux density and cooler operation. The tapped high-voltage windings and three filament windings provide flexibility in design. An electrostatic shield between the primaries and secondaries reduces power-line noise coupling. The primary arrangements allows use on virtually any power grid in the world.


$225.00
Click to read more
P-T162XSEATransformer - Hammond, Output, Single-Ended, 30 W

Special Order Item

  • Over designed for single ended tube output circuits (triode, tetrode or pentode tubes).
  • Enclosed (shielded), 4 slot, above chassis Type 'X' mounting.
  • Frequency response at least 20 Hz. to 20 Khz. at full rated power (± 1 db max. ref.

$193.01
Note: special order items require additional lead time. See our page on special order items.
Note: this is a special order item.
Click to read more
P-TF26477Transformer - Fender®, Power, for Tone Master

Fender® Original Tone Master Power Transformer. Equivalent to #026477.


$179.95
On Backorder
Click to read more
P-T1750X-YORKVILLETransformer - Hammond, Output, replacement for Yorkville / Traynor

Special Order Item

  • Replacements for Yorkville/Traynor Amps
  • Designed for drop in replacement of original units.
  • Physically, parts were designed to look similar to original factory units (where possible).
  • Material used & design specs. were kept as close as possible to the original part to preserve the stock "tone".

Starting at $165.71
Note: special order items require additional lead time. See our page on special order items.
Note: this is a special order item.
Click to read more
P-T176DTransformer - Hammond, Step-Up, 500VA

Special Order Item

Capacity: 500VA Features:



  • Single winding does not provide isolation, for use where equipment is already isolated and only voltage change is required.
  • World wide applications, 50 or 60 Hz.

$161.03
Note: special order items require additional lead time. See our page on special order items.
Note: this is a special order item.
Click to read more
P-T850LATransformer - Hammond, Audio Broadcast Quality

Special Order Item

Output to Line, Matching or Bridging
  • Deep-drawn steel case with tin plated finish, with two convenient 6-32 mounting studs with mounting hardware.
  • Sealed case and wax potted core internally for stable characteristics and long life.
  • Wide frequency response ± 0.5 db max. from 20 Hz. to 20 Khz. (except units over 5K ohms impedance, may be down 1 db @ 20 Khz.)
  • Insertion loss of apx. 1 db.
  • Maximum power level +15 dbm. with specified characteristics, or higher levels with reduced low frequency performance.
  • Distortion is apx. 1.5% @ 20 Hz.
$146.22
Note: special order items require additional lead time. See our page on special order items.
Note: this is a special order item.
Click to read more
P-T850HAAudio Transformer - Hammond, 150/600Ω, Line Isolation

Special Order Item

  • 150/600 Ohm Primary Impedance
  • 300/1200 Ohm Secondary Impedance
  • Deep-drawn steel case with tin plated finish, with two convenient 6-32 mounting studs with mounting hardware.
  • Sealed case and wax potted core internally for stable characteristics and long life.
  • Wide frequency response ± 0.5 db max. from 20 Hz. to 20 Khz. (except units over 5K ohms impedance, may be down 1 db @ 20 Khz.)
  • Insertion loss of apx. 1 db.
  • Maximum power level +15 dbm. with specified characteristics, or higher levels with reduced low frequency performance.
  • Distortion is apx. 1.5% @ 20 Hz. under full power.
  • Electrostatic shield between pri. & sec. connected to the green lead.
  • Humbucking construction
  • Balanced split windings on pri. & sec. for circuit versatility. Primary may be used as a secondary and vice versa for impedance matching.
  • Lead length: Min. 4"

$146.22
Note: special order items require additional lead time. See our page on special order items.
Note: this is a special order item.
Click to read more
P-TM9100OTransformer - Marshall, Output, 100 W, for JCM900

Genuine Marshall™ 100 watt output transformer for JCM900 and JCM2000.


$139.95
Click to read more
P-TM45OTransformer - Marshall, Output, for JTM45

Genuine Marshall™ output transformer for JTM45.


$135.00
Click to read more

Pages

(15 pages)
Don't see a product you're looking for? Send us your product suggestions!
Subscribe to RSS - Transformers & Chokes