Vacuum Tubes

The first electronic amplification of sound was done with Vacuum Tubes. We have pre-amp, power and rectifier vacuum tubes among other types in New Old Stock from the golden era of American & European manufacturing as well as current production tubes from today.
Vacuum Tube - 407A, Dual Triode, Medium MU
9-pin miniature double triode with separate indirectly heated cathodes. It is designed for use in amplifier, mixer, oscillator, multivibrator and clamp circuits. The useful frequency range extends through the VHF range.
Vacuum Tube - 417A, Western Electric, Triode
9-pin miniature triode with an indirectly heated cathode. It is intended primarily for grounded-grid operation in the input stage of broad band amplifiers.
Vacuum Tube - 4D32, Tetrode, Beam Power
Beam type aligned grid power amplifier. It has a unipotential oxide-coated cathode, a hard glass nonex bulb, and a glass base with short tungsten leads. The tube has a heater designed to operate from a 6.3 volt supply.
Out of Stock
Vacuum Tube - 50BM8 / UCL82, Triode, Pentode, Power
Miniature type triode-pentode designed for use as an AF amplifier by triode section and AF power amplifier by pentode section in radio receivers.
Vacuum Tube - 5881, Tung-Sol, Tetrode, Beam Power
The 5881 is the electrical equivalent to types 6L6 and 6L6GC except that the plate and screen dissipation ratings have been increased approximately 20 percent.
Vacuum Tube - 6060 / ECC801, Triode, Dual
Miniature type double triode employing the 9 pin glass button base, having the same general characteristics as the 12AT7 and as a frequency changer, opoerating at frequencies up to 500 Mc/s.
Out of Stock
Vacuum Tube - 6072-A, Triode, Dual
Low-noise, low-microphonic miniature twin triode designed primarily for use in the low-level stages of high-gain audio-frequency amplifiers.
Vacuum Tube - 6087 / 5Y3WGTB, Rectifier, Full Wave
Full-wave high-vacuum rectifier for use in power supplies of moderate current requirements. The tube incorporates a unipotential cathode which is internally connected to the filament.
Vacuum Tube - 6293, Beam Power Amplifier
Small, sturdy, beam power amplifier tube intended for pulse modulator service in both fixed and mobile equipment.
Vacuum Tube - 6384, Beam Power Amplifier
High-perveance beam power amplifier designed as a direct retrofit for the 6AR6 or 6098 in aircraft, military, and industrial applications
Vacuum Tube - 6386, Triode, Dual, Remote Cut-Off
Miniature medium-mu twin triode in which each section exhibits a remote-cutoff characteristic. It is designed primarily for use as a cascode radio-frequency amplifier, intermediate-frequency amplifier, or mixer
Vacuum Tube - 6679 / 12AT7, Dual Triode
Miniature high-mu twin triode suitable for use as a grounded-grid amplifier or as a frequency converter at frequencies below approximately 300 megacycles. Its electrical characteristics are essentially equivalent to those of the 12AT7.
Out of Stock
Vacuum Tube - 6680 / 12AU7A, Dual Triode
Medium-mu triode in the 9 pin miniature construction. It is particularly suited for use in general-purpose amplifier and phase-inverter circuits as well as for the multi-vibrator and oscillator applications.
Vacuum Tube - 6681 / 12AX7A, Triode, Dual
Miniature high-mu twin triode especially suited for use in resistance-coupled voltage amplifier, phase inverters, multivibrators, and other applications in which high voltage gain is desired.
Out of Stock
Vacuum Tube - 6A3, Triode, Power Amplifier
Filament type triode power amplifier designed for service in the output stage of audio amplifiers where high output and low harmonic distortion are desired. Its ratings and characteristics are similar to those of the 2A3 and 6B4G.
Out of Stock
Vacuum Tube - 6A5G, Triode, Power Amplifier
6A5G is a heater type power amplifier triode designed for the same service as types 6A3 and 6B4G. The tube is equipped with an octal base. This tube is quite free from hum so that no potentiometer is required for hum balance.
Vacuum Tube - 6AC5G, Triode, Power Amplifier
High-mu power output triode designed for service in dynamic coupled circuits using a type 76, 6P5GT/G or 6J5GT/G as a driver. Two 6AC5Gs may be used as a zero bias class B amplifier.
Out of Stock
Vacuum Tube - 6AD7G, Pentode
Triode-power amplifier pentode
Vacuum Tube - 6AR6, Tetrode, Beam Power
Beam power amplifier designed specifically for applications requiring relatively high peak plate currents at negative grid potentials. It is constructed to withstand relatively high plate potentials.
Vacuum Tube - 6AZ8, Triode, Pentode
Medium mu triode and a semi-remote cutoff pentode in the 9 pin miniature construction. It is intended for general purpose applications in both monochrome and color television receivers.
Vacuum Tube - 6CA7 / EL34, Mullard, Pentode
Power pentode of the glass octal type. This tube is suitable for all applications which require peak powers of up to 11 watts from a single tube or up to 100 watts from two tubes in the normal push-pull arrangement.
Out of Stock