VOLTAGE DIAGRAM

BAND - SWITCH SHOWN
AT 1ST POSITION. PUSH BUTTON TUNING (BUTTON * 1 DEPRESSED)
795-160OKC.

BAND - SWITCH SHOWN AT 2ND POSITION CLOCKWISE. BROADCAST BAND
540-1600 KC.

BAND - SWITCH SHOWN AT 3RD POSITION CLOCKWISE. SHORT WAVE BAND
49 METERS.

BAND - SWITCH SHOWN AT 4TH POSITION CLOCKWISE. SHORT WAVE BAND
25 TO 31 METERS

BAND - SWITCH SHOWN AT 5TH POSITION CLOCKWISE, SHORT WAVE BAND
16 TO 19 METERS

STRINGING DIAGRAMS

POINTER ADJUSTMENT
Move the dial pointer by means of the tuning control knob to see that it reaches the upper and lower limit as shown on stringing diagram (A). In the upper limit position measure the distance D - E and in the lower limit position measure the distance A - B. The distance from A and B must be the same u the distance from D to the distances are not equal, unclamp and move the pointer side on the string until they are the time. The pointer should be checked us at the upper and lower tirait to be on that it is night. The care to see that the pointer does not slip during this operation. Recleap the pointer Jide tightly to the stone and seal with nay quick-drying cement. Set the tuning gang wide open and proceed with operation 3.

REPLACING TUNING SLUG
If it becomes necessary to change. tuning slug proceed in the following manner: Set the gang to its wide open pou tion, unsolder and remove the old slug. Set the slug adjusting screw about half way down. Place the new alug in much a position that 14 inches of its length is above the coil form. Solder it in this position making sure that it does not allop during the operation and that the slug wire is straight Proceed to realign the set as shown in the chart.

REPLACEMENT PARTS