REPLACEMENT PARTS

Frequency Range of Receiver 535 - 1700 kc.
Power Requirement 105 - 125 volts 60 cycles Alternating Current (a-c) only.
Power Consumption: Receiver 30 watts Record Player 35 watts

Note: In case of dial light failure, replace the lamp (Mazda 47) as soon as possible to prevent damage to the 3525 tube.

ALIGNMENT INSTRUCTIONS

Equipment Required:

Modulated r-f signal generator; output meter; insulated screw driver; two of mid 400 volt and one 50 mmfd 400 volt condensers.

The receiver should be aligned with chassis and loop mounted in the cabinet. With the condenser completely closed the pointer should be checked so that it coincides with the two horizontal reference lines on the dial. Connect the output meter and signal generator as follows:

Output meter - Connect across voice coil and turn volume control to maximum.

Signal generator Connect the low side of the signal generator to the common Bumbus thru a la denser and keep the output as low as possible, then proceed in the sequence shown on the alignmer

ALIGNMENT PROCEDURE CHART