Alden, Inc. 1757 Schematic

Alden, Inc. 1757

Get a print!

Product Information:
Manufacturer:Alden, Inc.

Schematic Pages

PNG: Page 1 Rider Manual Volume 18

Schematics Content

Page 1:


Remove chassis from cabinet for alignment. A signal generator is required having the following frequencies: 455 KC and 1400 KC An output meter should be connected across the speaker. FIRST STEP: Connect the hot lead from the generator to the ANT. section cf the gang condenser, through a. MFD. condenser. The ground lead from the generator may be connected to any spot on the metal chassis. Turn the gang condenser to complete minimum capacity. Set the generator to 455 KC. Adjust the movable trimmers in the IF cans, until a maximum reading is noted on the output meter.
The volume control of the receiver should be turned to maximum during the IF and all subsequent alignment and the generator output as low as possible to prevent the AVC from working and giving false readings.

SECOND STEP: With the leads from the generator still connected as in IF alignment, adjust the generator to 400 KC. Set the dial pointer to 1400 KC on the dial scale. Adjust the oscillator trimmer until the signal is tuned in.

THIRD STEP: Remove the generator leads from the condenser. Connect the hot lead from the generator through a 200 MMFD. condenser to one of the leads which project from the back of the loop antenna. Connect the ground lead of the generator to the remaining lead. With the generator and the receiver still tuned to 1400 KC, adjust the antenna trimmer until a maximum reading is noted on the output meter.