Atwater Kent 32
Model: | 32 |
Manufacturer: | Atwater Kent |
Schematics Content
Page 1:
ATWATER KENT MFG. CO.
CONDENSERS
RESISTORS
TRANSFORMERS
CHOKES
Phone condonsor and grid bias resistor are mounted upon detector and & wf tube shelf. The plate bypass condenser is located adjacent to the 4th r-f socket. The antenna choke listed above is designated as the "choke coil" in the wiring diagram The antenna choke is located near the 1st r-f tube socket. The plate bypass condenser referred to in the above parts specification is listed as "fixed condenser" in the wiring diagram. While it is true that the wiring diagram illustrates a 3. meg detector grid leak, the Atwater - Kent parts list calls for the 2. meg unit mentioned above.
Model 35 Late
The parts used in the Model 35 Late, are the same 28 in Model 35 Early, except that the grid suppressors are 350 ohms each and are part # 8349 and are flat wire wound units.
Page 2:
ATWATER KENT MFG. CO.
Wiring Diagram of Models 30, 35 and 48. (In Model 35, one rheostat controls the three R.F. filaments and a fixed resistance is connected in series with the detector and two A.F. filaments.)
Wiring Diagram of Model 32