SWITCH MOVED 1 POSITION CLOCKWISE B.C. BAND

The above voltages are to be measured with the speaker connected

S.W. BAND

POLICE BAND

SET UP PROCEDURE Remove push button escutcheon. Turn the set on and leave operate a sufficient length of time to permit the tubes to reach their normal operating conditions.

NOTE: To simplify the set up and insure accurate adjustments the following pre-adjustments should be made.

Tighten all the " ANT " Trimmer screws just moderately tight. See Fig. 1,

FIG. 1 Turn the " OSC " screws to the left (counter-clockwise) until the end of the screw is about flush (even) with the top of the " ANT " padded condenser. Note: Care should be exercised when adjusting the " OSC " screws so that the selected station is not passed over, turn screws slowly.

It is essential that the frequency (kilocycles) of the station selected is within the range of the push button to be set for that station, see Fig. 1.

1. Turn the band switch to " B " position, first notch from left end. Using the station selector knob (upper right) carefully tune in the station to which the No. 1 push button is to be set. Note program.

2. Turn the band switch to the left (" A " and using a small screw driver, carefully turn the " OSC " screw to the right (clockwise) for the No. 1 push button (first screw on left in the upper row), until the station you tuned in (Manually) is heard again. Adjust for maximum output in speaker.

3. Adjust the No. 1 push button � � � ANT � � � adjusting screw for maximum volume in speaker. NOTE: If this adjustment does not seem to have much effect adjust loop antenna for miuimum signal from that station, then adjust the " ANT " screw for maximum signal.

4: Turn band switch one notch to right " B " then back to " A " to check if push button is correctly adjusted. There should be no change in tone quality when switched from one to the other.

5. The set-up for No. 1 push button is now complete. Set up remaining buttons to be set, following the same procedure, adjusting the " OSC " screw first, then the ANT padder screw.

6. After all the buttons have been set, they should be rechecked, turning the loop antenna for minimum pickup on each station to insure accurate adjustments.

To tune the receiver with the push buttons the Band Switch must be turned all the way to the left " A " then completely depress the button which represents the station you wish to hear.

Preliminary Output Meter Connections... Generator Ground Connection. Dummy Antenna to be in series with generator output. Position of Volume Control... Position of Tone Control...

Plate to Plate of 6F6's To chassis or Ground Lead See Chart Below
.. Fully On Treble or Speech

ALIGNMENT PROCEDURE CHART