Electronic Corp. of America 105, Early
| Model: | 105, Early |
| Manufacturer: | Electronic Corp. of America (ECA) |
Page 1 
Page 2 Schematics Content
Page 2:
ALIGNMENT PROCEDURE
The following equipment is necessary to properly align this chassis:
1. A signal generator which will provide an accurately calibrated signal at the frequencies listed.
2. An output meter.
3. A non-metallic screwdriver.
4. Any loop similar to the one used in the receiver.
PROCEDURE
1. Mount the loop in a vertical position on a block of wood so that it may be coupled parallel to the set loop.
2. Connect the loop to the output terminals of the signal generator.