INSTRUCTIONS FOR INSTALLING ELECTRONIC B POWER SUPPLY
1. INSTALL ELIMINATOR IN MOST CONVENIENT POSITION IN CAR, BEING SURE THAT ELIMINATOR IS SECURELY GROUNDED TO SOME GROUNDED METAL PART OF THE CAR.
2. CONNECT "HOT" SET LEAD TO H.S. TERMINAL, OF ELIMINATOR
3. CONNECT "HOT" BATTERY LEAD TO A.A. TERMINAL OF ELIMINATOR
4. CONNECT NEGATIVE RADIO SET LEAD TO B- TERMINAL OF ELIMINATOR,
5. CONNECT POSITIVE RADIO SET LEAD TO B+ TERMINAL OF ELIMINATOR.
6. IF RADIO SET HAS AN INTERMEDIATE VOLTAGE TAP, CONNECT IT TO BE TERMINAL OF ELIMINATOR. THIS INTERMEDIATE VOLTAGE SHOULD BE ADJUSTED IN ACCORDANCE WITH SET MANUFACTURER'S INSTRUCTIONS, THE VOLTAGE BEING MEASURED WITH A HIGH RESISTANCE VOLTMETER. IF THIS IS NOT AVAILABLE, THE SLOTTED ADJUSTING SHAFT IN THE CENTER OF THE B TERMINAL STRIP SHOULD BE TURNED TO ABOUT THE CENTER POSITION AND VARIED A LITTLE EITHER WAY UNTIL BEST RADIO RECEPTION IS OBTAINED.
7. IF RADIO SET B CABLE HAS SHIELDING, CONNECT IT TO THE TERMINAL OF ELIMINATOR. NOTE: - SOME RADIO SETS HAVE ONLY ONE B LEAD WHICH IS POSITIVE, THE NEGATIVE LEAD BEING THE SHIELDING, IN THIS CASE CONNECT THE SHIELDING TO THE B- TERMINAL AND TO THE G TERMINAL.