OPERATING INSTRUCTIONS
CAUTION: This instrument is equipped for operation on 110 volts D.C. or A.C., any frequency from 25 to 133 cycles per second. Before attempting to operate on any other voltage be sure that the proper adapters are connected and the instructions accompanying them are understood. Special adapters can be secured from the factory at a slight extra cost, for operating this receiver on automobiles, 32 volt farm light plants and 200 volt A.C. or D.C. ALWAYS plug cord into back of set before plugging into power supply. Cord for 110 volt or 220 volt heats moderately, as the cord contains resistance necessary for operation at these voltages. The 20 ft. aerial wire extending from the back of the set should be unwound, laid out along the floor or hung outside a window and is ordinarily all the serial required. No-ground connection should be used. Sometimes reSsults are better if the tip of the antenna wire is connected to a radiator or other ground connection or to an outside aerial,

TO OPERATE:
Turn left-hand knob to right as far as it will. go. Wait a few moments for tubes to heat. Turn right-hand knob slowly back and forth till a sta. tion is heard. Adjust this knob carefully to ge cure best tone and adjust left-hand knob to volume desired. When left knob is turned on. tirely to left a click is heard and power is turned off. When operating on D, C. current and set fails to operate after waiting & reasonable time for tubes to heat up, reverse power supply plug.

PHONOGRAPH:
Connect pick-up leads to single pole toggle switch, which may be mounted in large hole in rear flange of set. Unsolder black wire and 5 mfd condenser from ground lug of coil on under side of chassis and resolder to one side of toggle switch. Solder other side of switch to ground lug of coil.

SERVICE NOTES:
To remove set from cabinet, disconnect from power supply, remove knobs, remove back if com pact model, and unscrew the four felt headed screws on bottom of cabinet. To balance set remove from cabinet, turn tuning condenser plates completely out, attach a test oscillator delivering 1712 K.C. to antenna of set and adjust trimmers on tuning condenser to loud est signal. Change test oscillator signal to 1400 K.C., turn tuning condenser until signal is tuned in and check trimmers again without moving tuning condenser. If used in automobiles antenna stage should be trimmed to the car antenna at time of installation.

GUARANTEE:
This instrument is guaranteed for ninety days, within which period any part showing electrical or mechanical defect will be replaced without charge when returned prepaid to the factory.