ALIGNMENT
THE CHASSIS MUST BE REMOVED FROM THE CABINET IN ORDER TO ALIGN THE RECEIVER. CONNECT THE OUT PUT METER ACROSS THE VOICE COIL. CONNECT THE SIGNAL GENERATOR TO THE STANDARD HAZELTINE MODEL 1150 LOOP, AND COUPLE LOOSELY TO THE RECEIVER LOOP. SET THE RECEIVER VOLUME CONTROL AT MAXIMUM. THE TUNING CONDENSER PLATES SHOULD BE FULLY MESHED WHEN THE DIAL POINTER IS AT THE INDEX MARK AT THE LOW FREQUENCY END OF THE DIAL, THE SIGNAL GENERATOR OUTPUT SHOULD BE JUST SUFFICIENT TO OBTAIN HALF SCALE DEFLECTION ON THE LOWEST SCALE OF THE OUT PUT METER. SET THE SIGNAL GENERATOR TO 455 KC. ADJUST THE I.F. TUNING SLUGS FOR MAXIMUM OUTPUT IN THE FOLLOWING SEQUENCE: L4, L3, L2, L1. SET THE GENERATOR AND RECEIVER TO 1600 KC AND ADJUST OSCILLATOR TRIMMER C2 FOR MAXIMUM OUTPUT. SET THE GENERATOR AND RECEIVER TO 1400 KC AND ADJUST R.F. TRIMMER 04 FOR MAXIMUM OUTPUT