Kadette Radio Corp. L40 Schematic

Kadette Radio Corp. L40

Get a print!

$8.00
Product Information:
Model:L40
Manufacturer:Kadette Radio Corp. (International Radio)

Schematic Pages

PNG: Page 1 Rider Manual Volume 11

Schematics Content

Page 1:

Kadette Model No. L - 25

Kadette Model No. L - 41

Kadette Model No. L - 40
Start clock by turning starting knob (at rear) in direction of arrow. Set clock by turning " Set " knob (at rear) in direction of arrow. Clock re mains running regardless of any power switch position, including " OFF and will continue to fun as long as cord is plugged into a power supply outlet. Power current interruptions will stop the clock and it must be re-started. For continuous operation on radio, throw toggle switch (at rear) to RADIO. Note this switch has three positions, " RADIO " OFF " and " ALARM " To pre-set a desired station: (1) Throw toggle switch to " RADIO " (2) Tune in station desired with selector knob. (3) Turn volume well up (volume control knob). (4) Turn " ALARM "

Setting knob, at rear, in direction of arrow until the desired time for radio to turn appears at the calibration mark in the alarm set window on the clock dial (top-center of clock face). (5) Throw the toggle switch to " ALARM ". (6) Radio will turn " ON " at the time thus set, and will continue to operate for about 1/2 hours then turn off. (7) Do not pre-set more than ten hours prior to the time of desired program. To pre-set radio to TURN OFF at a predetermined time: (1) With radio playing, place toggle switch at rear, at " ALARM " position. (2) Turn " ALARM " set-knob, at rear, in direction of arrow until the desired time to shut off is indicated by the small Homan numerals in the upper portion of the. alarm set window on the clock face. NOTE: Do not pre-set to turn off for longer than 1/2 hours.

Voltage Readings
The following are the approximate readings when using a 1000 ohms per voltmeter. Voltage across speaker field is approximately 30 volts. Line voltage 117 volts.

Voltage Readings
The following are the approximate readings when using a 1000 ohms per volt voltmeter, Line voltage should be 117 volts.