Models 5D15WG-501 and 5025WG-502

Models 5D15WG-501 and 5D25WG-502 are similar to models 5D15WG-501X and 5D25WG-502X with the above exception

Tuning Frequency Range ... 540 to 1600 KC
Power Consumption ... 30 watts (At 117 volts AC)
Power Output ... 1.5 watt maximum, .9 watt (10% harmonics)

Parts List

Note A - Set dial pointer to 1400 KC Index line on dial light diffuser

Dial Calibration

In order to align the receiver, the dial pointer must be positioned on the dial string correctly with reference to the dial. Index lines are provided on the dial light diffuser for this purpose.

Before aligning the receiver (or when replacing the dial light diffuser) check the position of the diffuser strip, making certain that the two extreme index lines are aligned with the inner edges of the diffuser mounting bracket opening. The bracket should be crimped to prevent movement of the diffuser strip. To position the dial pointer, turn the large drive pulley to the maximum counterclockwise position. The dial pointer should be directly over the dial pointer index line. (See illustration).

Drive Cord Replacement

Turn the large drive pulley to the maximum counterclockwise position. Use a new 53 inch drive cord, tie one end to the tension spring and fasten the other end of the spring to the drive pulley. Install the cord as shown in the illustration. Wind 2 3/4 turns counterclockwise around the tuning shaft with the turns progressing away from the chassis. After string is in

Selectivity ... 55 KC Broad at 1000 Times Signal
Intermediate Frequency ... 455 KC
Speaker ... 5" PM Dynamic
Sensitivity (for .05 watt output) ... 25 microvolts average

NOTICE: There is a power rating label on the chassis. This label specifies the power supply on which the radio may be used, and identifies the radio as to chassis, dial and issue letter. When ordering parts or writing, give ALL information appearing on this label.

Parts List

In order to align the receiver, the dial pointer must be positioned on the dial string correctly with reference to the dial. Index lines are provided on the dial light diffuser for this purpose.

Before aligning the receiver (or when replacing the dial light diffuser) check the position of the diffuser strip, making certain that the two extreme index lines are aligned with the inner edges of the diffuser mounting bracket opening. The bracket should be crimped at one point to prevent movement of the diffuser strip. To position the dial pointer, turn the large drive pulley to the maximum clockwise position. The dial pointer should be directly over the dial pointer index line. (See illustration).

DRIVE CORD REPLACEMENT

Turn the large drive pulley to the maximum counterclockwise position. Use a new 53 inch drive cord, tie one end to the tension spring and fasten the other end of the spring to the drive pulley. Install the cord as shown in the illustration. Wind two turns clockwise around the tuning shaft with the turns progressing away from the chassis. After string is installed, stretch the tension spring and tie free end of cord to spring. Cut off excess string.

TUNING ASSEMBLY SERVICE

Exacting requirements in the tuning assembly make it impractical to replace the drive cord, coils and components in this assembly other than the trimmer condensers. Should the drive cord break, or components other than the trimmer condensers require service, the entire assembly must be ordered and replaced as a unit.

Selectivity ... 59 KC Broad at 1000 Times Signal

Intermediate Frequency ... 455 KC

Speaker ... 5" PM Dynamic

Sensitivity (for .05 watt output) ... 560 microvolts per meter average