Purotone Radio Corp. 4506 Schematic

Get a print!
Price: $8.00
In stock
Product Information:
Manufacturer:Purotone Radio Corp.

Schematic Pages

Schematics Content:

Page 1:

This model is a superheterodyne receiver for regular radio broadcast reception, using latest tow drain tubes for low power consumption. A self-contained antenna loop is incorporated which makes the use of an outside antenna unnecessary in most localities. It will function on 105 to 125 volts, 40-60 cycles AC, or 105 to 125 volts DC, A range of 540 to 1600 kilocycles is covered by the receiver.

1. Make certain that all tubes are in their proper place and sit secure in their sockets. A sketch, showing their location will be found on this sheet. To exchange tubes, remove the antenna loop by unscrewing the 2 lower screws on the wooden bracket.
2. If found that additional radio signal pick-up is required than is obtained by the inbuilt antenna loop, it is advisable to attach an outdoor aerial to the Aexible lead, extended from said loop aotcoda.

The knob on the left hand side is the power switch and volume control. When the control is in the extreme counter-clockwise position the power is " off. " From this position, a slight clockwise rota. tion turns the power " on, " and rotating the knob in this direction will increase the volume until full output is obtained.

The knob on the right hand side is the tuning knob which operates the pointer and tuning condenser. A reduction drive insures easy and accurate selection of all stations within the range of the band. The pointer is phosphor luminous, and will maintain luminous power in the dark, when exposed regularly to bright daylight.


I.F. Connect antenna fead of the signal generator to R.F. section and ground lead of signal generator to receiver chassis. Connect an output meter across the voice coil. Rotate the volume control to maximum. Apply 455 K.C. signal to control grid of 12SK7 RF, tube through a .05 capacitor. Second I.F. transformer to be aligned first, then 1st I.F. transformer, by adjusting trimmers.

R.F. Connect antenna lead to antenna, and ground lead of signal generator to receiver chassis. Adjust both generator and receiver to 1600 K.C. Peak oscillator trimmer for maximum output. Set the signal and receiver dial to approximately 1300 K.C. Adjust the antenna trimmer for maxi mum output.


Please note: we carry a wide range of products which will fulfill the specifications above. Please use our search function or browse our products to find what you need!