ALIGNING PROCEDURE

Align I.F. Trimmers at 455 KC.

1. Turn dial to extreme high frequency end.
2. Set signal generator to 1660 kc.
3. adjust oso. trin. to secure signal.
4. Adjust R.F. trim. to secure maximum sig.
5. Set signal generator to 1400 ko.
6. Turn dial to secure, signal.
7. Cheek R.F. saddle to see output at maxima.
8. Adjust saddle to secure max. output, if necessary.
9. Recheck alignment at 1650, re-adjust R.F. trim. if necessary
10. Set signal generator to 600 kc.
11. Adjust dial to secure signal.

12. Rock dial while adj. shunt pad for max signal.
13. Realign osc. and R.F. trimmers at 1650.
14. Recheck 1400 kc to 600 kc points for alignment.
15. Repeat procedure from step 5 on if 1400 and 600 are out much.
16. Set signal generator to 1000 ko.
17. Tune in signal.
18. Install pointer * Set to 100 * on dial.