You are here

2019 Clearance Sale

Filter these results
Sort By:
products per page
View Mode: List View · Grid View
P-PG10XPickguard - Fender®, for American Stratocaster, 11-hole
Colors Available:

Fits most American and Mexican stratocasters


Starting at $20.95
Click to read more
P-QHFA16TDiode - Hexfred, 16A, 600V
High performance, ultrafast diodes. Improve efficiency, reduce noise, allow higher frequency operation.
$4.00
$2.92
You save: 27%
Click to read more
R-VB-XLPotentiometer - Bourns, Linear, Knurled, Conductive Polymer

Linear, .75" bushing length. Conductive polymer, 0.625" W x 0.625" L x 0.5" D body. ¼" watt, 300° rotation. ¼" shaft diameter. Solder lugs. 3/8" bushing. Knurled split shaft.


Starting at $8.56
Click to read more
R-V2M-N1Potentiometer - Neohm, 2M, Linear, Twist Tab Mount

Composition element control designed for applications where bushingless controls are required. Phenolic shaft insures insulation if control is used on a hot chassis. Pot can be adjusted from the top by screwdriver (or knob on 1/4 knurled shaft) or from the bottom of the chassis. Great for antique radios. 24mm body2" solid shaft length¼" diameter. 2M linear. Twist tab mount.


$0.25
Click to read more
C-MCS-100Capacitor - MusiCap, 100V, Film & Foil Polypropylene

Critical loudspeaker crossovers deserve to have a transparent product specific to the application. Speaker MusiCaps, with their thicker leads, are a revelation in well-designed crossover networks. While a fully MusiCap-ed crossover is supreme, just installing MusiCaps in the tweeter circuit will reveal much additional detail and nuance. Many prominent high-end loudspeaker manufacturers have been using MusiCaps in their top models for years.


$22.80
Starting at $21.65
You save: 5%
Click to read more
P-A-SL12B3P-8Speaker - Sica Bass, 12", Neodymium SL12B3P, 350W, Steel

Clearance - New Old Stock speaker. Sica Standard Light bass speaker.



  • 3” voice coil Kapton former and aluminium winding
  • Neodymium magnet
  • Cooling radiator to reduce power compression
  • 96.9 dB sensitivity


Overall Diameter 12" Impedance 8 ohm Rated Power 350 watts Magnet Neodymium Basket Steel Overall Weight 7.17 lbs Response 70-6k Voice Coil Diameter 3" Magnet Weight 12.7 oz


$99.95
$89.95
You save: 10%
Click to read more
P-GT-GP200Parts Kit - Grover, Bushings, Washers, Screws
Bushings, washers and screws for Grover® Machine Heads.
$175.00
$149.95
You save: 14%
Click to read more
P-PG11XPPickguard - Fender®, for Standard Stratocaster, 11-hole
Colors Available:
Original Fender® double fat pearloid, 4-ply, 2 Hum 11 Hole.
NOTE: The humbucker route is not compatible with covered humbuckers. Only uncovered humbuckers will fit in this route without further modification. Humbucker mounting screw holes are NOT pre-drilled.
Starting at $29.22
Click to read more
S-W130Cord - Power, UK, 2.5M

Detachable 3 conductor power cord for United Kingdom wall outlets. Cord end is IEC connected. GTSA-3 (Marshall™ type) 18 AWG. 2-1/2 meters (about 8 feet) length, 1/4” outer diameter.


$4.95
Click to read more
P-GKLU-KCD3805GLMachine Head - Kluson, 6/line, Contemporary Diecast, Gold

6-in-a-line. New Kluson® 19:1 ratio die-cast tuning machine set for contemporary guitars. These state of the art diecast tuners are designed for usage on contemporary guitars and utilize the same mounting hole common to Grover 305 series medium tuners as well as the common Gotoh tuner with the mounting screw located offset at approximately 7 O'clock or 5 O'clock depending on left or right handed application. Uses the common modern 25/64 in. (10mm) peghole with a hex head type screw-in bushing and single mounting screw. All mounting hardware is included.


$70.00
$39.68
You save: 43%
Click to read more
Don't see a product you're looking for? Send us your product suggestions!
Subscribe to RSS - 2019 Clearance Sale